The aim of the work is to design a plain wood combustion boiler of 60 t/h output. Fuelling component analysis has been added to the basic boiler parameters. Stechiometric calculations were performed for given fuel composition. Thermal efficiency was set after making thermal balance. Separate convective areas and boiler proportions were designed together with separate steam output parameters (temperature, pressure, amount). Design documentation was added.

The aim of this thesis is to design a desulphurisation device for the pulverized coal boiler K3 in heating plant Olomouc. In this boiler, coal with sulphur content is burnt. Emissions SOx from the boiler output are much higher than the emission limits for SOx, which comes into force 1.1.2016. Therefore it is necessary to build a desulphurisation device, which will cause a significant reduction of SOx emissions and compliance with the emission limits. The thesis consists of two parts - theoretical and practical. The theoretical part states SO2 emission limits and describes various methods for flue gas desulphurisation. In the practical part I chose a semi-dry desulphurisation method with fluid reactor. It determines a stoichiometric amount of combustion air and determines the boiler efficiency. For the required parametres is given a calculation of desulphurisation, the design of some parts of the device and design arrangement.

The thesis contains calculations of a boiler burning natural gas. For designated values of steam pressure, temperature and steam power is made a proportion design and heat calculations.

To design a grate boiler with a natural circulation for burning of a pine bark with an output 18t/h is a primary objective of this dissertation. Individual parts of a boiler and it´s heat transfering surfaces were calculated after the working out of stoichiometric calculations from given element analysis of fuel. All computations have to fulfill several parameters: boliler output, temperature and pressure of an overheated steam.

The work deals with design of steam grate boiler with a output of 25 t/h, parameters of steam output p = 5.5 MPa, t = 475 °C and a temperature of feed water 105 °C. It is a boiler with natural water circulation by evaporation surfaces. Wood biomass is boiler fuel. The proposal consists of stoichiometric calculations, determination of boiler efficiency, thermal calculations and determinion geometric parameters of the boiler and its heat transfer surfaces. The boiler drawing is a part of the work.

The work is focused on the design heat generation source in my chosen location. The entire facility should be designed to meet the basic requirements of the client. The primary objective of this work is alternatively propose solutions to perform basic balance calculations and determine the performance of each device. Based on the location selected diagram to produce annual heat needs and recommend the best possible solution.

The aim of this thesis is to propose a grate steam boiler for combustion of straw from wheat, rye and barley output of 20 t / h The calculation is performed by stoichiometric calculation of elemental analysis to calculate the dimensions of a boiler heating surfaces. Default superheated steam can be used mainly for electricity generation.

This master’s thesis deals with the issue of design heat recovery steam generator. In the first part is realized calculation of stoichiometry and further the thermal balance of the boiler. The boiler was divided on the basis of thermal analysis in two heating surfaces that have been designed separately. The thesis also includes structural design and drawings of evaporator, economizer and their compilation.

This thesis describes the design of hot air boilers for burning wood chips for the production of process air at 500 ° C and a given flow rate 2 Nm3 / s. The work deals with general combustion and fuel economy of biomass boilers.

This diploma thesis describes the design of steam boiler for combustion natural gas, which has a steam power 80t/hour. In the first phase is performed calculation of stoichiometric amount of combustion air and flue gas. After that follows constructional proposal of the combustion chamber. Furthermore continue by calculation heating surfaces of the boiler. In conclusion, the thesis is focused on designing the injections. To check the accuracy of the results is recalculated heat balance the whole boiler.