Les attaques par canaux auxiliaires sont apparues dans la deuxième moitié des années 1990. Ces attaques exploitent différentes informations qu’il est possible de collecter lors de l’exécution d’un algorithme sur un appareil cryptographique. Il est ainsi possible, entre autres, de mesurer la consommation d’énergie d’un appareil cryptographique, ou encore d’observer le temps d’exécution d’un certain algorithme sur un appareil. C’est à ces deux sources d’in- formation que nous nous intéressons dans ce travail. Après une présentation des concepts utiles à la lecture du travail et de l’état de l’art des attaques et des contre-mesures du domaine, nous abordons les résultats de nos recherches effectuées lors de ce travail de thèse. Nous présentons d’abord nos contributions aux attaques par mesure de consommation d’énergie :(1) une approche com- binant apprentissage semi-supervisé et attaques par templates pour retrouver le poids de Hamming des différents bytes d’une clé de chiffrement et (2) une approche utilisant des techniques d’apprentissage automatique pour attaquer une implantation protégée d’AES. Ensuite, nous abordons les contre-mesures investiguées durant nos recherches qui se résument (1) en la possibilité de rendre l’ordre des instructions d’AES le plus aléatoire possible en jouant sur la relation de dépendance entre celles-ci ainsi qu’en (2) l’étude de l’application partielle (sur un sous-ensemble de données) de certaines contre-mesures, afin de protéger les données sensibles d’un algorithme. Enfin, nous terminons ce travail par l’emploi de la programmation orientée aspects comme manière d’implanter des contre-mesures pour les attaques temporelles (sur RSA) et pour les attaques par mesures de consommation d’énergie (sur AES). / Doctorat en Sciences / info:eu-repo/semantics/nonPublished

Magnesium alloys have been widely explored as potential biomaterials, but several limitations to using these materials have prevented their widespread use, such as uncontrollable degradation kinetics which alter their mechanical properties. In an attempt to further the applicability of magnesium and its alloys for biomedical purposes, two novel magnesium alloys Mg-Zn-Cu and Mg-Zn-Se were developed with the expectation of improving upon the unfavorable qualities shown by similar magnesium based materials that have previously been explored. The overall performance of these novel magnesium alloys has been assessesed in three distinct phases of research: 1) analysing the mechanical properties of the as-cast magnesium alloys, 2) evaluating the biocompatibility of the as-cast magnesium alloys through the use of in-vitro cellular studies, and 3) profiling the degradation kinetics of the as-cast magnesium alloys through the use of electrochemical potentiodynamic polarization techqnique as well as gravimetric weight-loss methods. As compared to currently available shape memory alloys and degradable as-cast alloys, these experimental alloys possess superior as-cast mechanical properties with elongation at failure values of 12% and 13% for the Mg-Zn-Se and Mg-Zn-Se alloys, respectively. This is substantially higher than other as-cast magnesium alloys that have elongation at failure values that range from 7-10%. Biocompatibility tests revealed that both the Mg-Zn-Se and Mg-Zn-Cu alloys exhibit low cytotoxicity levels which are suitable for biomaterial applications. Gravimetric and electrochemical testing was indicative of the weight loss and initial corrosion behavior of the alloys once immersed within a simulated body fluid. The development of these novel as-cast magnesium alloys provide an advancement to the field of degradable metallic materials, while experimental results indicate their potential as cost-effective medical devices.

The purpose of this project is to manage restaurants using a software system called GRIPED (Get the Right Price Every day). The system is designed to cover quality control, food cost control and portion control for better management of a restaurant.

MESHWR / Department of Hydrology and Water Resources / Irrigation uses the largest amount of water, estimating to 60 % of the total consumption in South Africa. For this reason, the efficient and reasonable use of water by irrigators is of paramount importance. Thus, this study was carried out to assess the suitability of Wetting Front Detectors (WFDs) in improving water management. The study involved an on-farm survey; field installations; testing of WFD technology on selected plots within the scheme; identification of the crops grown; documentation of the current water supply and documentation of the challenges faced by farmers in relation to irrigation. These were carried out to identify the ideal situations in the scheme. Irrigation scheduling helps farmers to know when to irrigate and amount of water required supplying for crop need. The study presented WFD, as a means of improving irrigation efficiency. The WFD is a simple tool that helps farmers to identify what is occurring around the root zone. Four plots with a representative farmer in each of the plot were identified in four Blocks (Block 1 farmer 1, Block 1 farmer 2; Block 2 farmer 1; Block 3 farmer 1 and Block 4 farmer 1). On-farm experiment of the WFD was carried out. However, with Block 4 farmer 1, insufficient data was collected due to absence of LongStop equipment. This also involved field installation, observation and measurements of the LongStops (LSs) and FullStops (FSs) WFDs at placement depth of 30 cm, 45 cm and 60 cm. The efficiency of an irrigation system depends on different performance indicators including Irrigation Efficiency (IE), Conveyance Efficiency (CE), Application Efficiency (AE), Storage Efficiency (SE), Distribution Uniformity (DU) and Coefficient uniformity (CU). In this study, attention was focused only on DU; CU and SE, as represented by water moisture availability. All the DU for all plots in blocks were below the standard DU of furrow, which is 65%. Farmer 2, in Block 1, had a higher DU and CU, which were 60% and 68%, respectively- considered closer to the standard DU value. For the other farmers, their DU and CU prior to irrigation were very low, which indicated that there was uneven distribution of water in these plots. The poor DU in Block 1 farmer 1, indicated by the uneven infiltrated water, resulted in excessive watering. Analysing the WFD showed that farmers were performed well in all the Blocks, except for farmer 1 in Block 1. Average soil moisture content result indicated high water loss through deep percolation. The highest volumes of water recorded before and after irrigation were 131 ml and 159 ml, respectively, for LS90 placed at a depth of 90 cm in Block 2 farmer 1. High volumes of water were collected in Block 1 farmer 2, Block 2 farmer 1 and Block 3 farmer 1 before and after irrigation. The result showed that, the more placement depth down the soil profile, the more accumulation of water in the LSs. Therefore, it was recommended that farmers continue to use the WFD as a tool for irrigation efficiency. However, there is need for improvement and capacity building in using the tool.

Indiana University-Purdue University Indianapolis (IUPUI) / This thesis proposes a family of non-isolated bidirectional converter in order to interface dc and ac variables. Such power electronics solutions guarantee: (i) bidirectional power flow between dc and ac converter sides, (ii) independent control in both converter sides, (iii) high level of integration with a reduction of one power switch and its drive circuits, (iv) implementation of two functions by using a unique power conversion stage and (v) reduction of the capacitor losses. Despite proposing new power converter solutions, this thesis presents an analysis of the converters in terms of pulse-width-modulation (PWM) strategy, dc-link capacitor variables, and suitable a control approach. Solutions for single-phase, three-phase and three-phase four-wire systems are proposed by employing a converter leg with three switches. A possible application of this converter is in Vehicle-to-Grid (V2G) systems and interfacing dc microgrid with a utility grid. In addition to the new power electronics converters proposed in this thesis, an experimental setup has been developed for validation of the simulated outcomes. The proof-of-concept experimental setup is constituted by: DSP, Drivers & Integrating Board, Power Supply and, Power Converter & Heat-Sink .

Indiana University-Purdue University Indianapolis (IUPUI) / The existing topologies of solar micro inverter use a number of stages before the DC input voltage can be converted to AC output voltage. These stages may contain one or more power converters. It may also contain a diode rectifier, transformer and filter. The number of active and passive components is very high. In this thesis, the design of a new solar micro inverter is proposed. This new micro inverter consists of a new single switch inverter which is obtained by modifying the already existing single ended primary inductor (SEPIC) DC-DC converter. This new inverter is capable of generating pure sinusoidal waveform from DC input voltage. The design and operation of the new inverter are studied in detail. This new inverter works with a controller to produce any kind of output waveform. The inverter is found to have four different modes of operation. The new inverter is modeled using state space averaging. The system is a fourth order system which is non-linear due to the inherent switching involved in the circuit. The system is linearized around an operating point to study the system as a linear system. The control to output transfer function of the inverter is found to be non-minimum phase. The transfer functions are studied using root locus. From the control perspective, the presence of right half zero makes the design of the controller structure complicated. The PV cell is modeled using the cell equations in MATLAB. A maximum power point tracking (MPPT) technique is implemented to make sure the output power of the PV cell is always maximum which allows full utilization of the power from the PV cell. The perturb and observe (P&O) algorithm is the simplest and is used here. The use of this new inverter eliminates the various stages involved in the conventional solar micro inverter. Simulation and experimental results carried out on the setup validate the proposed structure of inverter.

An investigation of the bombing of automated teller machines (ATMs) with intent to steal cash contentof ATMs. This is inclusive of the impact on society (banks clients) and banking institutions as well as the danger it poses to the general public and public and private law enforcement personnel. / (M.Tech. (Security Management))

Text in English / In this study, the research problem sought to explore, identify and acknowledge the value of vehicle tracking technology within the South African Police Service (SAPS). National legislation in the Republic of South Africa allows the SAPS and private organisations, such as Tracker, to create partnerships to successfully combat crime, such as vehicle related crimes. Data was collected by means of a literature study, together with semi-structured interviews that were individually conducted with non-commissioned officers of the SAPS: West Rand Flying Squad. These members are deployed daily, in an operational environment, to deal with the recovery of stolen and robbed motor vehicles; they utilise vehicle tracking technology to fulfil this function. A detailed study of literature relating to national legislation, SAPS directives, media and newspaper reports as well as library resources and international studies was conducted. The research indicates the importance of vehicle tracking technology in assisting specialized units within the SAPS to successfully and efficiently track and locate stolen or robbed motor vehicles. It is evident that the use of this type of technology has become an invaluable tool to the SAPS: West Rand Flying Squad members in their daily duties. Furthermore, members at grassroots level understand and appreciate the assistance and value of technology, especially as the technology enables them to effectively recover stolen or robbed motor vehicles, and to successfully arrest the perpetrators responsible for these thefts. The recommendations made in this study may provide a number of solutions to the South African government, SAPS, insurance industry and the general public, regarding the value of vehicle tracking technology. In addition, the study indicates how this technology can effectively assist in curbing vehicle crimes and the recovery of stolen or robbed motor vehicles; in the process, recovery affects the arrests of criminals, thus saving the economy a significant amount of money due to crimes of this nature. / Police Practice / M.A. (Criminal Justice)

An investigation of the bombing of automated teller machines (ATMs) with intent to steal cash contentof ATMs. This is inclusive of the impact on society (banks clients) and banking institutions as well as the danger it poses to the general public and public and private law enforcement personnel. / (M.Tech. (Security Management))

Introduction: Central Line-Associated Bloodstream Infections (CLABSIs) are a major cause of increased mortality, morbidity and healthcare costs in neonatal intensive care units (NICUs) patients. Despite CDC's efforts to reduce infection rates, patients often suffer consequences. The objective of this study is to perform a systematic review of strategies utilized in the neonatal population and evaluate them with the current CDC's guidelines to assess the effectiveness of bundles in preventing CLABSI in NICUs. Methods: A systematic literature search was conducted using CINAHL Plus with Text, Cochrane Database of Systematic Reviews and MEDLINE from January 2008 up to 2018. There were multiple search terms used and these included "neonate OR newborn OR infant", "CLABSI OR central line-associated bloodstream infection", "intervention OR prevention" and "bundle". The search solely focused on the outcome of infant patients. Therefore studies were excluded for the following criteria: being non-peer reviewed, being published before 2008, and being a case in which CLABSI was assessed in patients outside the NICU. See Table 4 and 5 for further information. Results: Eight articles were eligible for inclusion all of which CDC's guidelines were implemented in their strategy of intervention. The systematic review showed that adherence to care bundles decreases infection rates drastically. All eight articles reported a significant decrease in CLABSI rates following the implementation of the bundle set by CDC with two studies achieving a CLABSI rate of zero. Author's Conclusion: Implementation of care bundles showed a success in reducing CLABSI rates in the NICUs; however none of the studies endorsed a specific bundle application utilized to achieve its intended goal. Some practices adopted CDC's guidelines more than others and those showed a greater decrease in infection rate. In addition, it is evident that nurses deliver the best care when preventing an infection. Further research is needed to assess the effectiveness of a specific bundle element.