In this thesis, a joint symbol timing and carrier frequency offset estimator is proposed for orthogonal frequency division multiplexing (OFDM) systems. The estimator exploits both redundancy in the cyclic prefix and pilot symbols for channel estimation. The proposed scheme includes a transparent sequence that is added to the OFDM symbol in frequency domain. Comparing with conventional methods, the proposed architecture has the advantage of better bandwidth usage since it does not require extra sub-carriers. The PAPR problem can be suppressed due to constant envelope property of the added sequence in time domain. Moreover, the optimal power allocation ratio of the transparent sequence is determined by minimizing the bit error rate of the system using simulation experiments.

In mobile radio systems, the bandwidth of spread spectrum signals for CDMA system is very wide. If the bandwidth exceeds the coherence bandwidth of the channel, the signal is seriously distorted by the multiple propagation paths. The available bandwidth is divided into a lot of small parts in Multi-carrier-CDMA system. Selecting the number of subcarriers according to the environment of channel will make the bandwidth of spread spectrum signals smaller than the coherence bandwidth of channel. And then the system can overcome the question of multiple propagation paths. The performance of Multi-carrier CDMA system is sensitive to frequency offset. Frequency offset results from Doppler shift due to mobile movement, as well as from a mismatch between the carrier frequency of local oscillators at the transmitter and receiver. Consequently, the subcarriers¡¦ orthogonality are lost, causing Inter-carrier Interference (ICI). The interference of other subcarriers will make the error of estimated channel coefficients. Effect of frequency offset will lower the performance of the combing detector that needing channel estimated. In this thesis, we propose a method to correct the frequency offset. Using the relation of two continuous received signals to estimate the frequency and compensate it. We will analysis and compare this method in different condition. Simulation results will demonstrate the performance of this proposed method.

Reliable timing and frequency synchronization is a major requirement in orthogonal frequency division multiple-access (OFDMA) systems as synchronization errors can result in inter-symbol-interference (ISI) and inter-carrier-interference (ICI) in the received signal, which severely degrade system performance. Thus, the objective of the proposed research is to develop, analyze, and prototype timing and frequency synchronization techniques for downlink (DL) and uplink (UL) OFDMA transmissions. For synchronization in DL OFDMA transmissions, we have developed conditions to select appropriate Zadoff-Chu sequences as training symbols that allow timing synchronization in the presence of large carrier frequency offsets (CFO). Using the proposed training block, we have designed training signal detection, timing synchronization, and integer CFO estimation algorithms. We have further proposed the training signal design for frequency synchronization in DL coordinated multi-point (COMP) transmissions, in which a user has to synchronize to multiple base-stations at the same time. In this respect, a frequency synchronization algorithm for DL COMP receiver has been designed using the proposed training signal along with its hardware implementation to analyze real-time performance. For frequency synchronization in UL OFDMA transmissions, we have proposed a null sub-carrier-based CFO estimation algorithm, and carried out its identifiability and acquisition range analysis. The proposed algorithm supports both sub-band and generalized sub-carrier allocations. We have also designed a CFO estimation and compensation algorithm for UL single-carrier frequency division multiple-access (SC-FDMA) transmissions. The proposed algorithm is based on parallel factor analysis and supports interleaved sub-carrier allocation. In addition, it guarantees the identifiability of CFO estimation and allows the system to operate on full load. Detailed simulations results have been provided along with discussions on computational requirements, which reveal that the proposed algorithms provide significant improvements in performance and efficiency compared to state of the art schemes in the literature.

No description available.

ITC/USA 2007 Conference Proceedings / The Forty-Third Annual International Telemetering Conference and Technical Exhibition / October 22-25, 2007 / Riviera Hotel & Convention Center, Las Vegas, Nevada / A single-tone frequency estimator for a non-uniformly sampled sinusoid is proposed. A nonuniformly sampled sinusoid may be generated from the received training sequences of a telemetry link. The frequency of the sinusoid matches the carrier-frequency-offset (CFO) of the received signal, and estimation of this quantity allows a receiver to compensate for the CFO. The performance bounds of this type of estimator have been investigated in the literature, though little work has been published on practical algorithms. The estimator proposed in this paper is a generalization of phase-increment estimators previously described in the literature. It exhibits a low computational complexity yet converges to theoretical bounds at high SNR. The paper argues that a periodic training sequence structure, combined with the new estimator, allows for a high-accuracy and lowcomplexity CFO compensator.

<p>The demand for reliable high rate and efficient communication is ever increasing. In this thesis we look at two different problems in such systems, and their possible solutions.</p><p>In recent years orthogonal frequency division multiplexing (OFDM) has gone from a promising data transmission technique to become a mainstream technique used in several current and future standards. The main attractive property of OFDM is that it is inherently resilient to multipath reflections because of its long symbol time. However, this comes at the cost of a relatively high sensitivity to carrier frequency offsets (CFOs).</p><p>In this thesis we present a technique for CFO estimation in OFDM systems that is based on locating the spectral minimas within so-called null or virtual subcarriers embedded in the spectrum.~The spectral minimas are found iteratively over a number of symbols and is therefore mainly useful for frequency offset tracking or in systems where an estimate is not immediately required, such as in TV or radio broadcasting systems. However, complexity wise the estimator is relatively easy to implement and it does not need any extra redundancy beside a nonmodulated subcarrier. The estimator performance is studied both in a channel with additive white Gaussian noise and in a frequency selective channel environment.</p><p>A goal for many years has been to be able to implement as much as possible of a radio system in the digital domain, the ultimate goal being so called software defined radio (SDR). One important part of an SDR receiver is the high speed analog-to-digital converter(ADC) and one path to reach this goal is to use a number of parallel, time-interleaved, ADCs. Such ADCs are, however, sensitive to sampling instant offsets, DC offset and gain offset.</p><p>This thesis also discusses iterative time-delay estimators (TDEs) utilizing adjustable fractional-delay filters. The TDEs could for example be used to estimate and calibrate the relative delay between the ADCs comprising the time interleaved ADC. TDEs using a direct correlator and an average squared difference function are compared. Furthermore, an analysis of the effects of the batch length dependence is presented.</p> / Report code: LiU-Tek-Lic-2006:33.

<p>This thesis discusses and investigates the estimation of carrier offset frequency in</p><p>orthogonal frequency division multiplexing (OFDM) mobile systems. The investigation</p><p>starts by using Mobile WiMAX wireless communication specifications described</p><p>in IEEE 802.16e as the primary system setup. Under this setup orthogonal</p><p>frequency division multiple access (OFDMA) is used as a physical layer scheme; it</p><p>also involves the use of pilots in the OFDM symbol for channel estimation.</p><p>Although OFDM is resistant to multipath fading, it requires a high degree of synchronisation</p><p>to maintain sub-carrier orthogonality. Therefore the level of performance</p><p>of the system depends first on the accuracy in estimating the carrier frequency</p><p>offset and then the estimation of the channel. Maximum likelihood estimator</p><p>is used for estimating carrier frequency offset; its performance under different conditions</p><p>for example SNR, number of virtual carriers needed for estimation etc. are</p><p>simulated and compared with theoretical results. The optimality of IEEE 802.16e</p><p>specifications was also examined during the simulations and results analysis.</p>

The demand for reliable high rate and efficient communication is ever increasing. In this thesis we look at two different problems in such systems, and their possible solutions. In recent years orthogonal frequency division multiplexing (OFDM) has gone from a promising data transmission technique to become a mainstream technique used in several current and future standards. The main attractive property of OFDM is that it is inherently resilient to multipath reflections because of its long symbol time. However, this comes at the cost of a relatively high sensitivity to carrier frequency offsets (CFOs). In this thesis we present a technique for CFO estimation in OFDM systems that is based on locating the spectral minimas within so-called null or virtual subcarriers embedded in the spectrum.~The spectral minimas are found iteratively over a number of symbols and is therefore mainly useful for frequency offset tracking or in systems where an estimate is not immediately required, such as in TV or radio broadcasting systems. However, complexity wise the estimator is relatively easy to implement and it does not need any extra redundancy beside a nonmodulated subcarrier. The estimator performance is studied both in a channel with additive white Gaussian noise and in a frequency selective channel environment. A goal for many years has been to be able to implement as much as possible of a radio system in the digital domain, the ultimate goal being so called software defined radio (SDR). One important part of an SDR receiver is the high speed analog-to-digital converter(ADC) and one path to reach this goal is to use a number of parallel, time-interleaved, ADCs. Such ADCs are, however, sensitive to sampling instant offsets, DC offset and gain offset. This thesis also discusses iterative time-delay estimators (TDEs) utilizing adjustable fractional-delay filters. The TDEs could for example be used to estimate and calibrate the relative delay between the ADCs comprising the time interleaved ADC. TDEs using a direct correlator and an average squared difference function are compared. Furthermore, an analysis of the effects of the batch length dependence is presented. / Report code: LiU-Tek-Lic-2006:33.

Orthogonal Frequency Division Multiplexing (OFDM) plays an important role in the implementation of high data rate communication. In this thesis, the problems of data detection and channel and carrier frequency offset estimation in OFDM systems are studied. <p>Multi-symbol non-coherent data detection is studied which performs data detection by processing multiple symbols without the knowledge of the channel impulse response (CIR). <p>For coherent data detection, the CIR needs to be estimated. Our objective in this thesis is to work on blind channel estimators which can extract the CIR using just one block of received OFDM data. A blind channel estimator for (Single Input Multi Output) SIMO OFDM systems is derived. The conditions under which the estimator is identifiable is studied and solutions to resolve the phase ambiguity of the proposed estimator are given.<p>A channel estimator for superimposed OFDM systems is proposed and its CRB is derived. The idea of simultaneous transmission of pilot and data symbols on each subcarrier, the so called superimposed technique, introduces the efficient use of bandwidth in OFDM context. Pilot symbols can be added to data symbols to enable CIR estimation without sacrificing the data rate. Despite the many advantages of OFDM, it suffers from sensitivity to carrier frequency offset (CFO). CFO destroys the orthogonality between the subcarriers. Thus, it is necessary for the receiver to estimate and compensate for the frequency offset. Several high accuracy estimators are derived. These include CFO estimators, as well as a joint iterative channel/CFO estimator/data detector for superimposed OFDM. The objective is to achieve CFO estimation with using just one OFDM block of received data and without the knowledge of CIR.

This thesis discusses and investigates the estimation of carrier offset frequency in orthogonal frequency division multiplexing (OFDM) mobile systems. The investigation starts by using Mobile WiMAX wireless communication specifications described in IEEE 802.16e as the primary system setup. Under this setup orthogonal frequency division multiple access (OFDMA) is used as a physical layer scheme; it also involves the use of pilots in the OFDM symbol for channel estimation. Although OFDM is resistant to multipath fading, it requires a high degree of synchronisation to maintain sub-carrier orthogonality. Therefore the level of performance of the system depends first on the accuracy in estimating the carrier frequency offset and then the estimation of the channel. Maximum likelihood estimator is used for estimating carrier frequency offset; its performance under different conditions for example SNR, number of virtual carriers needed for estimation etc. are simulated and compared with theoretical results. The optimality of IEEE 802.16e specifications was also examined during the simulations and results analysis.