The aim of this thesis is to describe the advantages of simultaneous utilization of photovoltaic and wind electricity in an autonomous system, supplying the household with electricity without connection to the electrical grid. The most used methods of connecting photovoltaic modules and wind generators to chemical batteries are discussed. Several maximum power point tracking methods and their properties are described. A block schematic diagram of an autonomous off-grid system utilizing chemical accumulators is proposed. The system also contains an inverter producing standard mains voltage 230 VAC to supply common household appliances. A Quasi-Square Wave converter topology was chosen for all three power converters. An experimental 180 W output power QSW converter with one controllable switch was designed, simulated with Pspice, manufactured and tested to verify the efficiency of the topology. Excellent agreement was found between predicted and measured efficiency at full output power. Efficiency for reliable operation varies between 89% and 92,2% at full power and depends mainly power inductor and MOSFET used. After successful evaluation of QSW topology, the power converters for the main system were designed. Because of higher power, the converters were designed as four-phase, whereas each phase contains two controllable switches to boost efficiency mainly in low-power area. The most critical and difficult part of the project was to design the mixed-signal control sections for the converters to ensure proper switching of two controllable MOSFETs in each phase. For user interactivity, main control board with graphic LC display, Ethernet module and SD memory card slot was also manufactured.