No description available.

No description available.

No description available.

M.S.

In the past, most research on soil mechanical properties was carried out for cohesionless soils in the fields of civil and geotechnical engineering. Little research has been carried out for mechanical properties of agricultural soil, which are essential for designing soil engaging tools in agriculture. In this study, unconsolidated undrained triaxial compression tests were performed to study the effects of moisture level and confining pressure on a sandy loam soil. The soil specimens tested had three moisture levels, and they were high (27-29% d.b.), medium (19-21% d.b.) and low (9-11% d.b.). The confining pressures used for the triaxial tests were 50, 100, and 150 kPa. Soil specimen was loaded at a strain rate of 1%/min. Measurements from the tests included stress-strain curve, shear strength, Young’s modulus, Poisson’s ratio, angle of internal friction, and cohesion. A model was developed using the Discrete Element Method (DEM) and computed by Particle Flow Code in three dimensions (PFC3D), a common DEM software. The model simulated the triaxial compression tests, and the model specimen was an assembly of 5-mm spherical particles which were defined by a set of micro parameters. During simulations, soil shear strength was monitored under different confining pressures. Through sensitivity analysis, it was found that most of the micro parameters affected the simulated soil shear strengths and the stress-strain behaviours. The most influential micro parameter was particle friction coefficient. This micro parameter was calibrated with the data from triaxial tests for different combinations of soil moisture levels and confining pressures. The calibrated particle friction coefficients varied from 0.2 to 1.0. The calibrations were done through matching the shear strengths between simulations and measurements, and the relative errors ranged between 0 and 6 %. / October 2015

No description available.

Increasing levels of nitrate (NO3-) in groundwater have become a major environmental and health concern. In situations where NO3-concentrations in the soil-water system pose an environmental hazard, water table management may be a desirable practice to reduce such pollution. Careful management of N applications is also believed to reduce NO3- levels. / A field experiment was conducted in 1996 and 1997 at St. Emmanuel, Quebec, about 30 km South-West of Macdonald Campus of McGill University, to investigate the effect of water table management (WTM) and N fertilizer combinations on potentially leachable NO3- and denitrification rates in the top soil layer (0--0.15 m). The field was planted with monocrop corn (Zea mays. L) in both years. Treatments consisted of a factorial combination of two water table managements, free drainage (FD) and subirrigation (SI) (about 1.0 m and 0.6 m, respectively, below the soil surface) and two N fertilizer rates, 200 kg ha-1 (N200) and 120 kg ha-1 (N120). / Water table management had a significant effect on reducing NO3 - concentrations in the soil profile. Subirrigation treatment reduced NO3- in the top soil layer by 41% and 15% in 1996 and 1997, respectively. Similarly, NO3 - levels were 50% and 20% lower in N120 compared to N200 treatment. / Climatic conditions (rainfall and temperature) played a large role in regulating denitrification rates. Due to drier and cooler conditions in 1997, denitrification rates were lower compared to 1996, leaving more NO3 - in the soil profile. Following harvest, this high NO 3- concentration may be subject to leaching.

No description available.

No description available.

No description available.