<p dir="ltr">The Boeing-AFOSR Mach-6 Quiet Tunnel (BAM6QT) was used for a set of experiments aiming to characterize the stability regimes of stagnation point injection in noisy and quiet flow across an array of different injected gases. Four gases were used in this experiment: air, helium, carbon dioxide, and argon. These gases were injected at varying thrust coefficients, ranging from 0.0516 to 0.5666, using a 7 degree half-angle cone with a 19 mm radius spherical nose and a single 1.93 mm-radius sonic jet in the center of the model. The primary data collected consists of schlieren images gathered at a sample rate of 76 kHz. These data were then analyzed using a shock tracking software to measure the physical locations of flow features as well as through spectral proper orthogonal decomposition (SPOD) to analyze specific modes in the flow.</p><p dir="ltr">Through this analysis, it was observed that three principle modes exist in stagnation point injection regardless of the injecting gas: a high frequency vortex-coupled mode, a low frequency Mach-shock-rigid mode, and a hybrid mode residing between these two modes. The first two modes were observed in all stability regimes, whereas the hybrid mode was only observed in the bifurcated regime. Furthermore, the unsteady regime was observed to be mostly characterized by this first, vortex-coupled mode. Conversely, the steady regime was observed to be driven by the Mach-shock-rigid mode instead. This transition was measured to occur as the thrust coefficient was increased.</p><p dir="ltr">This research also found that freestream noise resulted in an amplified and widened frequency range within the Mach-shock-rigid mode. This same freestream noise did not appear to have an impact on the other two principle modes; however, in some cases the noise produced in the Mach-shock-rigid mode due to this freestream noise did in fact mask the other principle modes.</p><p dir="ltr">Lastly, it was observed that the thrust coefficient, in and of itself, is not the sole indicator of stability in stagnation point injection. Across the different injected gases in this research, transition between the stability regimes did not in fact occur at a constant thrust coefficient value. Additionally, even within the same injected gas, this transition did not occur at the same thrust coefficient value between noisy and quiet runs—indicating an effect of freestream noise on stability.</p>

Supersonic jet exhaust plumes produce noise in jet engines, which has been a problem in the aerospace field. Researchers are working on ways to reduce this turbulent mixing noise, with little modification to the engine and nozzle. Prior work has shown that total temperature non-uniformity is a noise reduction technique which introduces a stream of cold flow into the heated jet. This method has been shown to cause changes in the exhaust plume and result in a 2±0.5 dB reduction of peak sound pressure levels. The goal of this work is to reveal underlying changes in the spatial-temporal structure of plume instability and turbulence caused by non-uniform total temperature distributions. Studies have demonstrated several methods of jet noise reduction by modifying the turbulent mixing in the exhaust plume. Large-scale turbulent structures have been shown to be the dominant source of noise in heated supersonic jets, especially over long, streamwise distances. Therefore, a large field-of-view measurement is desirable for studying these structures. Time-Resolved Doppler Global Velocimetry (TR-DGV) with a sampling frequency of 50 kHz is used to collect flow velocity data that is resolved in both time and space. The experiments for data collection were performed on a heated supersonic jet at the Virginia Tech Advanced Propulsion and Power Laboratory. A converging-diverging nozzle with a diameter Reynolds number of 850,000 was used to generate a perfectly expanded, heated flow of Mach 1.5 and a nozzle pressure ratio (NPR) of 3.67. The unheated plume was introduced at the center of the nozzle, with a total temperature ratio (TTR) of 2. Comparison of the mean velocity fields shows that the introduction of the cooler temperature flow in the thermally non-uniform case results in a velocity deficit of about 10% compared to the thermally uniform case. The method of spectral proper orthogonal decomposition (SPOD) was used to reveal the large-scale, coherent noise producing mechanisms. SPOD results indicate that the thermally non-uniform case showed a decrease in turbulent kinetic energy compared to the uniform case at all frequencies. Coherent fluctuations start developing further upstream in the thermally non-uniform case. The addition of the unheated plume results in a disruption in the propagation of the Mach waves from the shear layer into the ambient. The results indicate that the total temperature non-uniformity results in a modified exhaust plume and mean flow distribution at the nozzle exit, compared to that of a thermally uniform flow, which past studies have indicated is a method to reduce jet noise. / Master of Science / Supersonic jet exhaust plumes produce noise in jet engines, which has been a problem in the aerospace field. Researchers are working on ways to reduce this turbulent mixing noise, with little modification to the engine and nozzle. Traditionally, nozzles produce a single stream of uniform temperature flow. This work identifies a method of reducing jet noise, known as thermal non-uniformity. A stream of cold flow is introduced at the center of the nozzle. Applying this method to jet engines can result in quieter aircraft. Large-scale turbulent structures are the dominant noise producing source in supersonic free jets. To further understand the relationship between coherent structures and acoustic jet noise, spectral analysis is used to educe these structures from the flow. This study uses velocity data collected using Time-Resolved Doppler Global Velocimetry (TR-DGV). The study compares the results of a thermally uniform and a thermally non-uniform heated supersonic jet of Mach 1.5. The goal of this study is to determine the effects of thermal non-uniformity on large-scale coherent structures using a modal decomposition analysis known as spectral proper orthogonal decomposition (SPOD). The results from this study show that the thermally non-uniform cases contained less turbulent kinetic energy compared to the thermally uniform cases. Coherent fluctuations start developing further upstream in the thermally non-uniform case. The addition of the unheated plume results in a disruption in the propagation of the Mach waves from the shear layer into the ambient. The results indicate that the total temperature non-uniformity results in a modified exhaust plume and mean flow distribution at the nozzle exit, compared to that of a thermally uniform flow, which past studies have indicated is a method to reduce jet noise.