This thesis proposes control circuit, that will be used in laboratory stand. The first part contains components that interact with the control circuit. The second part deals with the actual design of the control circuits, their design, appropriate selection of components and wiring. Third part deals with the assembly of the entire device and its commissioning.

This master’s thesis describes the function and realization of the laboratory test equipment designed for measuring and analysing of collector current iC and voltage uCE courses during the opening and closing process of a power IGBT transistor. The opening and closing times toff and ton of the new power transistor IGBT are changing in the range from tenths to the ones s, so the reading of current iC and voltage uCE proceeds in a very short time. The measuring circuit of this test equipment is based on a short-time discharging of a condenser battery to the inductive load over the measured transistor. Consequently it is possible to replace the power supply whose maximum output power would otherwise have to be in the range of ones MW. In the final part of this thesis there are described properties and design of a high-frequency sensor with the Rogowski coil, which can be used for reading collector current course during opening and closing time of the measured transistor IGBT. Collector current iC and voltage uCE courses can be analysed with a storage oscilloscope.

This diploma thesis is focused on the design of a rotating rectifier for a synchronous generator. Based on defined requirements, the new rotating rectifier concept has been created that allows a greater current range than existing rectifier used by Siemens Electric Machines s.r.o. The thesis is divided into five parts. The first part deals with the search of existing rotating rectifiers and other design possibilities. The requirements for the rotating rectifier were defined in the second part of the thesis. The following section deals with both electrical design of rectifier elements and varistors. The fourth part of the diploma thesis describes the thermal analysis. On the basis of thermal analysis the operating conditions of the rotating rectifier were determined. The last part of the thesis is devoted to mechanical and modal analysis. Based on these analyses, the strength and operability of the new rotating rectifier concept were verified.

The thesis describes the procedure during the proposal of the driver circuits for the GaN MOSFET transistors, which are known for their fast switching especially. In the first instance of this thesis the issue of GaN MOSFET transistors is described and also the thesis describes the different types of MOSFET transistors in the way of their electrical and mechanical attributes. The specific type driver circuit is stated in the thesis, which was selected in the semestral thesis. For this circuit the boost converter with an output power 600W and high switching frequency 800kHz was proposed as an attempt measurement circuit. This boost converter was measured after its construction was done. The waveforms captured by the oscilloscope are commented also. In the conclusion the assessment is done about this new technology of power switching transistors.

This thesis contains a complete description of the design and implementation of a 500W transformer soldering station. This soldering station includes a half-bridge DC/DC converter with a pulse transformer. The device works with a very low voltage and extremely high output current. Therefore some parts have a special design to ensure the proper equipment function. Coaxial transformer with very low leakage inductance (nH units) is unusual. A synchronous rectifier is another special feature working with low voltage and high output current of the transformer. The finished functional prototype consists of a soldering station and a soldering adapter.