This Master´s thesis deals with heterogeneous photochlorination of polyolefins and especially with the photochlorination of polypropylene itself. In the theoretical part the available information about properties, manufactory and application of chlorinated polyolefins, specifically polyethylene and polypropylene, is provided. The basic principles of the photochemistry are described, which are further applied to the issue of photochemistry chain reactions and photochemical halogenations, mainly photochlorinations. The practical part includes design and realization of few types of equipment for the heterogeneous photochlorination of polypropylene done at low temperatures (to 50° C) by gaseous chlorine in bulk or chlorine suspended in suspension of PP in CCl4. Series of chlorination was accomplished, which was varied in the type of PP, in the way of dosage Cl2 and in the period of high pressure mercury lamp irradiation (1–90 minutes). The chlorine content in prepared samples was determined by the gravimetry with ATR-FTIR spectroscopy, as well as by the Shöniger combustion method. Their accuracies were than compared. The chlorine content dependence on the period of chlorination and on the porosity of initial PP was established.

The quality of raw water is deteriorating with the continuous increase in environmental pollution. Raw water is being modified to drinking water by technological processes, and it is therefore necessary to put increased demands on the efficiency of these technological processes and their possible innovation. Due to the fact that raw water is contaminated with different types of pollutants, it is necessary to continuously control the drinking water supplied to the public distribution network in order to ensure its quality. Drinking water treatment is still unable to treat the raw water perfectly, its pollution is only reduced to acceptable standards. For this reason, it is indispensable that the quality of drinking water is being checked regularly and at the same time the efficiency of individual technological processes of drinking water treatment is assessed. This includes screening analysis or eventually ecotoxicological tests. The thesis focuses on the efficiency of technological processes of drinking water treatment. Within the experimental part, samples of raw water and samples of water after each separation stage have been collected at the drinking water treatment plant in the Czech Republic. These samples have been subjected to ecotoxicological tests and screening analysis. Based on the ecotoxicological tests carried out on Thamnocephalus platyurus, Lemna minor and Vibrio fischeri, we can assume the emergence of harmful chlorinated by-products, resulting to nearly 100% mortality in T. platyurus. The results of the screening analysis carried out indicate, after the extraction of specimens by the SPE method using HPLC/MS, that the most effective method for the removal of hormonal substances is ozonization.