Sludge treatment and disposal are one of the most important parts of sewage treatment. These are economically challenging parts, and therefore emphasis is placed on effective dosing. The dose should be as small as possible but also the highest dry matter output. The main target of this diploma thesis is therefore to show that it is possible to achieve the same or better degree of drainage of the sludge if different flocculant/coagulant ratio is applied to the sludge. Diploma thesis deals with determination of the optimal combination of chemical doses during sludge dewatering. The thesis contains two parts, practical and theoretical. The theoretical part consists of research, overview of processed research and works in the area of sludge dewatering. The second part is a description of laboratory measurements and evaluation of results.

This dissertation thesis focuses on the removability of algal organic matter (AOM) by coagulation during water treatment and also on the influence of AOM on the coagulation of other substances present in source water. Special emphasis is put on the description of coagulation mechanisms. The effectiveness of AOM removal by coagulation was investigated by coagulation tests performed with optimized doses of coagulants (aluminium or ferric sulphate) under different pH values. Peptides and proteins contained in cellular organic matter of cyanobacterium Microcystis aeruginosa were used in the experiments since they have been previously reported to disturb the coagulation process. Moreover, peptides and proteins underwent coagulation experiments together with kaolin particles, representing clay particles in turbid waters, in both the presence and absence of coagulants to investigate the effect of AOM on the coagulation of turbid waters. To enable the description of coagulation mechanisms, AOM were characterised in terms of charge, functional groups, molecular weight and ability to form dissolved complexes with coagulant metals. The experimental results demonstrated that the removability of peptides and proteins is greatly dependent on pH value and on the properties of the involved particles or molecules....

The diploma thesis deals with the stability determination of model O/W (30/70) emulsions at 25°C. In fact, the time and emulsifier concentration (Tego Care PS) dependences of physical properties (aging) were monitored. In the second part of the work, the influence of conservant on emulsion stabilities were studied. In order to study physical properties of emusions rheometry, differential scanning calorimetry (DSC) and optical microscopy were employed. The rheological measurement provided information on viscosity and viscoelastic modulus. DSC experiments used the repeated freezing/thawing cycles which allowed monitoring of changes in crystallization temperature of water present in emulsions and melting enthalpy of ice formed during the cooling. The optical microscopy was used to examine the change in oil droplet size in the course of emulsion destabilization and phase separation. In this case the image analysis was carried out using program HarFA. The results showed that due to the emulsion creaming, the oil droplets diffuse and aggregate which causes phase separation. Those processes were quickest for the emulsion with lowest emulsifier concentration 0.1 % (destabilization during 51 days) The emulsions with emulsifier concentration about 1.5 and 1.3 % were stable at least for 4 months. The presence of the coemulsifiers increased the elastic modulus and descreased the phase difference due to the network formation. It was shown that for the stability determination is necessary to use conservant due to risk of microbial contamination. DSC experiments allowed to distingush samples prepared under different conditions. Lower rotational speed during emulsion preparation caused the appearance of two melting and crystalization peaks while for higher speed only one peak was observed.

The aim of the master´s thesis is the topic of the treatability of surface water with the focus on the process of suspension formation. For this work I took water samples from five different places around the Brno Dam which has contended with water quality deterioration for a long period. With these water samples, the series of jar coagulation tests were done with the application of three different commonly used coagulants. In the theoretical part of the master´s thesis I deal with the composition and attributes of surface water and the technology of its treatment. Each process of treatment is briefly described here with the emphasis on the process of suspension formation. The experimental part of the master´s thesis summarizes and presents the results gained through the coagulation tests in the laboratory. I evaluate the influence of different parameters on final effectiveness of water treatment and I try to find an optimal amount of coagulant, pH and speed of fast or slow mixing. Finally I compare the suitability of each coagulant and the influence of the sampling site on the effectiveness of water treatment.