1 |
Behaviour and analysis of embedded cantilever wall on a slopeOng, Chin Chai January 2007 (has links)
[Truncated abstract] The feasibility of using interlocked light gauge sheet piles to form a deep cross-sectional wall embedded in a residual slope or with a berm support is explored. This thesis compares the performance of a large section modulus sheet pile wall as an alternative to a concrete diaphragm wall, acting as an embedded cantilever wall on a slope (ECWS) by means of experimental centrifuge tests, numerical models and analytical methods. Abaqus (Hibbitt, Karlsson and Sorensen Inc, 1997) was used to conduct extensive numerical trials on the structural performance of the sheet pile wall model prior to the actual physical testing. The Abaqus results showed that the integrity of the interlock and reduced modulus action (RMA) due to slippage along the interlocked joint did not cause premature buckling of the thin wall even at the ultimate load. Further, a comparative study using centrifuge tests on 1:30 scaled models and Plaxis analysis demonstrated that under the worst condition with high water table, the rigid sheet pile wall of 1.32 m cross-sectional width carried a higher ultimate surcharge load with a much lower top of wall deflection, compared to a more flexible 0.6 m thick cracked concrete diaphragm wall. The analysis of the wall/soil/slope interactions for an ECWS involves many inter-dependent variables in addition to the complications of considering an adjacent slope or a berm support. It is difficult for existing analytical approaches to take all these factors into account, and some form of numerical analysis, calibrated through field data and results from centrifuge model tests is necessary. From the observations of the centrifuge tests and finite element analysis, major assumptions about the failure of a stiff ECWS in a rotational mode were deduced and adopted in the proposed limiting equilibrium method (Leq). The plane strain Leq ECWS Abstract ii analysis is based on the framework of minimum upper bound limiting equilibrium with planar failure planes and a Mohr-Coulomb soil model. As compared to the traditional limit equilibrium analysis, the Leq method is a fully coupled analysis using the shear strength reduction technique (SSR). New formulations are proposed for the development of horizontal active and passive pressure distributions based on the experimental and FE models. The proposed active pressure profile used is derived by combining the Coulomb and Krey method, and empirically back-figured to curve-fit the centrifuge tests by Morris (2005). The proposed passive pressure profile of a rigid rotational wall in failure is adjusted to allow for an adjacent slope or berm support through a presumed elasto-plastic deformation instead of a linear rigid translation of the passive wedge. ... A parametric study was later undertaken using the Leq method to develop a series of non-dimensionalised graphs to study and draw summarised conclusions on the behaviour of the ECWS. The final conclusions on the comparative study of the centrifuge tests, Plaxis and Leq analyses demonstrated that the alternative light gauge steel sheet pile performed very well as an ECWS. A key factor in the performance of the sheet pile wall was attributed to the large 1.32 m cross-sectional width of the interlocked sections. This provided high bending stiffness and high moment stability from shear stresses acting on the back and front faces of the wall.
|
Page generated in 0.1166 seconds