none

Ultrafine-grained(UFG) AZ31 Mg alloy was obtained by equal-channel angular extrusion(ECAE) and subsequent annealing at elevated temperatures. The basal texture component for ECAEed material is located on the Z plane of the ECAEed billets. Tensile tests were performed at temperatures between room temperature and 125¢J, and strain rates used ranging from 3*10-5 to 6*10-2 s-1. The experimental results showed that a high tensile yield stress of 394 MPa was obtained at room temperature under a strain rate of 3*10-3 s-1. Strengths of UFG AZ31 specimens were greatly improved due to grain refinement. It was found that strain rate sensitivity of UFG AZ31 alloy increased significantly from 0.024 to 0.321 with increasing temperature. The constant k of Hall-Petch equation, £m=£m0 +kd-1/2, decreased with increasing temperature, and decreasing strain rate. Negative k values were ontained at 75¢J and 100¢J under a strain rate 3*10-5 s-1. When compressed along X, Y and X45Z billet orientations, strain localization within shear bands was found in UFG AZ31 specimens. Shear bands are formed inclined near 45 to the compression axis. The smaller the grain size, the thinner the shear band. Different Hall-Petch constant k were found in specimens deformed along different orientations, which is caused by different deformation mechanisms. The formation of tension twins is the primary deformation mechanism for compressed X and Y samples, and basal slip is responsible for the deformation of X45Z sample. tension twins were found in 0.46 £gm grain size specimens.

Hexagonal closed packed (hcp) materials, in contrast to cubic materials, possess several processing challenges due to their anisotropic structural response, the wide variety of deformation textures they exhibit, and limited ductility at room temperature. The aim of this work is to investigate, both experimentally and theoretically, the effect os severe plastic deformation, ultrafine grain sizes, crystallographic textures and number of phases on the flow stress anisotropy and tension compression asymmetry, and the mechanisms responsible for these phenomena in two hcp materials: AZ31B Mg alloy consisting of one phase and Zn-8wt.% Al that has an hcp matrix with a secondary facecentered cubic (fcc) phase. Mg and its alloys have high specific strength that can potentially meet the high demand for light weight structural materials and low fuelconsumption in transportation. Zn-Al alloys, on the other hand, can be potential substitutes for several ferrous and non-ferrous materials because of their good mechanical and tribological properties. Both alloys have been successfully processed using equal channel angular extrusion (ECAE) following different processing routes in order to produce samples with a wide variety of microstructures and crystallographic textures for revealing the relationship between microstructural parameters, crystallographic texture and resulting flow stress anisotropy at room temperature. For AZ31B Mg alloy, the texture evolution during ECAE following conventional and hybrid ECAE routes was successfully predicted using visco-plastic self-consistent (VPSC) crystal plasticity model. The flow stress anisotropy and tension-compression (T/C) asymmetry of the as received and processed samples at room temperature were measured and predicted using the same VPSC model coupled with a dislocation-based hardening scheme. The governing mechanisms behind these phenomena are revealed as functions of grains size and crystallographic texture. It was found that the variation in flow stress anisotropy and T/C asymmetry among samples can be explained based on the texture that is generated after each processing path. Therefore, it is possible to control the flow anisotropy and T/C asymmetry in this alloy and similar Mg alloys by controlling the processing route and number of passes, and the selection of processing conditions can be optimized using VPSC simulations. In Zn-8wt.% Al alloy, the hard phase size, morphology, and distribution were found to control the anisotropy in the flow strength and elongation to failure of the ECAE processed samples.