The master’s thesis is focused on desing high-speed ethernet switch based on circuit FPGA. The switch is able to divide one data stream, created from ethernet frames to the two data streams with half data flow.

This diploma thesis deals with the ideological design and realization of digital room thermostat and a temperature sensor selection. The device is designed as three units communicating wirelessly. Outdoor unit and control units sensor provide data for the control circuit of microcontroller ATmega16. Microcontroller choose the boiler operation based on senzor data. Thermostat can be remotely controled

This diploma project summarizes a theoretical introduction regarding the issue of traffic light control. Further there is industrial communication discussed, where they are the Ethernet / IP protocol and the Modbus TCP protocol described more in detail. The following is the description of the Logix series programmable controllers. Then the diploma follows up with market research in order to find the most suitable development kit which is used as a trial prototype. Then it is concerned with a development kit with a communication module from AND-TECH company. Software was developed on them, more specifically a library for processor ports, memory and the Modbus TCP protocol. After verifying the functionality of the software, the hardware design was started. From the first site it is development kit and module and from the second site there are input and output circuits. There must be the assessment of the results found during the test operation. The end of the document describes incorrect steps that were repaired in hardware.