Gun-drilling is one of the highly efficient tools for deep-hole making. The drilled hole possesses good size, positioning, roughness, roundness, and straightness. When the deep-hole is drilled, it is easy to cause wear at the tool-chip and tool-work interfaces at the serious condition so that the gun-drill is subjected to larger feed force. If the feed force exceeds the critical load, then the cutting edge of the gun-drill is broken. However, nowadays the device to measure the feed force in the gun-drill press is not available. This study develops a gun-drill press which possesses two new functions as follow: (1) to measure and to record the feed force during the drilling process;¡]2¡^to return the gun-drill when the feed force exceeds a set value. These two functions can be used to detect the serious breakage of the gun-drill. According to the practice drilling test, the performance of this press can be obtained. Results show that the feed force can be measured using different feed speeds. The gun-drill can stop and return to its origin position when the feed force exceeds the set value. Hence, the performance test of this new machine meets the above-mentioned functions. Using this press, the relationship between the feed force and the wear of cutting edge is investigated at the same feed speed. Results show that wear occurs on the cutting edge of the gun-drill, and the wear area increases with increasing drilling time so that the feed force is also increased. The wear grows from the outer side of the cutting edge to the inner side.

The diploma work deals with the evaluation of force load procedure problems when using reaming head MT3 depending on selected criteria of surface integrity of machined hole. It is possible to eliminate some unwanted elements when reaming by force load procedure analysis. These negative elements can influence both the tool e.g. its previous wear and the defect of a newly made hole.

Theoretical study describes force analysis and quality of surface when milling. In the experiment the emphasis is on determining forces and surface quality in milling in response to changes in feed rate. Especially determination of specific cutting force kc and cutting force Fc at materials from aluminium alloy AlSi9Cu3, titanium alloy Ti6Al4V and steel C45, the used tool was a milling cutter for high feeds. In the experimental section is furthermore contained statistical evaluation data which demonstrate a certain prediction changes of cutting load and surface roughness when changing feeds.