This thesis covers the development of complex HIL simulator for the fifth car door. The beginning of the thesis is dedicated to theoretical research in the area of In-the-Loop testing. Practical part describes development of HIL simulator complemented by power electronics part. A simulation environment Matlab/Simulink was used for control design and analysis. Before the beginning of the work was measured signal part of control unit and specific signal sequences were identified. The control was applied on sbRIO device from National Instruments company with the implementation of a model on FPGA. Specific requirements for sensing speed and generation of communication signals lead to creation of unique hardware for application needs. The result of the thesis is complex HIL simulator with intuitive GUI and possibility of simulations a wide range of DC motors.

JURČA Jan: The manufacturing of sheet metal part by deep draw technology. Thesis of Master´s Studies, the 5th Year of Study, the School-year 2008/2009, The Institute of Manufacturing Technology, Department of Machining, FSI VUT Brno.The thesis deals with the project of manufacturing the part of the car body – the fifth door by deep draw technology. The material is zinc-coated sheet metal HX220YD EN 10292. Mechanical properties and suitability of the material are evaluated by mechanical tests. The structure of the material is evaluated by metalography scratch pattern. The analysis of draw process and manufacturability of the part is made by calculations and AutoForm software. The production line, necessary machinery and construction solution of draw tool for the manufacturing the part are determined. Last section deals with economical evaluation of the production.