We present an analysis from MMS satellites where we detected the strongest parallel currents from their data during the months May till November 2017. The strongest parallel current in July happened 2017-07-16 at 6 o’clock. At this event we found a change in the magnetic flow density at the locations: A. Svalbard, which would have resulted in an aurora borealis if it was not for the summer light. B. Antarctic, which visibly did result in an aurora australis. By examine the source of the parallel current, we looked near the Lagrange point L1 between Earth and the Sun and could observe how the flow pressure and magnetic field changed. This motivated the investigation by looking at the sun pictures by helioviewer, where we could observe an outburst the 2017-07-14, which turned out to be the requested source of this event.

The Generalized Weighted Residual Method (GWRM) is a recently developed time- spectral method for parabolic or hyperbolic initial-value partial differential equations. In this paper, spatial subdomains, used in this method, are analyzed. Subdomains are used to enhance efficiency by dividing entire domains into smaller parts that can be independently solved for and then combined to get the final solution. An automatic grid mapping algorithm for spatial subdomains, called "Compressive Method", is presented and applied to Burgers' viscous equation. The error of the solution, as compared to the analytic solution, is compared for this compressive Method and the uniform grid case. Results show that accuracy can be gained at a small extra cost, using this compressive Method. Conclusions are that this adaptive algorithm shows great potential for further development.

Vigren et al. (2015) presents an integral expression to calculate the ion number density around a low activity comet immersed in the solar wind's convective electric field. A certain parameter of the integral takes values of either 1 or 0 depending on whether a corresponding ion trajectory is feasible or not. The criteria used in the paper has been found not to be strict enough, yielding overestimated ion number densities in the cometary wake. The present project finds two new options for the criteria, one analytical and one numerical. The new numerical condition is tested in the same computations done in the original paper and compares the results of the old and new criteria. The new conditionis found to correct the previous error. / <p>Projektet gjort inom: Fördjupningskurs i fysik - projektkurs, 5.0 hp. Kurskod:1FA566.</p>

Cette étude fait partie d'un projet plus large appelé SIPHORE (SIngle gap PHOtoneutralizer energy REcovery injector), visant à améliorer l'efficacité globale de l'un des mécanismes par lesquels le plasma est chauffe, dans un réacteur de fusion nucléaire, à savoir le système d'injection de neutres (IDN). Une composante importante d'un système IDN est le neutraliseur de faisceaux d'ions de haute énergie. SIPHORE propose de substituer le neutraliseur à cellule à gaz, utilisé dans les systèmes IDN actuels, par un photo-neutraliseur exploitant le processus de photo-détachement dans des cavités Fabry Perot. Ce mécanisme devrait permettre une efficacité globale η> 60% du système IDN, nettement plus élevée que celle actuellement possible (η <25% pour ITER). Le travail de thèse porte sur l'étude de faisabilité d'une cavité optique avec des propriétés adaptées aux systèmes IDN. Dans ce contexte, le problème de la détermination d'une conception de la cavité optique appropriée a été tout d'abord pris en considération et l'analyse théorique ainsi qu'expérimentale d'un résonateur optique ont été effectuées. Les problèmes lies aux niveaux élevés de puissance optique intracavité (~3 MW) nécessaire pour un taux de photo-neutralisation adéquat ont ensuite été prises en compte. A cet égard, nous avons traite a la fois le problème des effets thermiques sur les miroirs de la cavité en raison de leur absorption de la puissance optique intra-cavite (~1 W) et celui associe à la nécessité d'un faisceau laser d'entrée de puissance élevée (~1 kW) pour alimenter le résonateur optique. / This work is part of a larger project called SIPHORE (SIngle gap PHOtoneutralizer energy RE-covery injector), which aims to enhance the overall efficiency of one of the mechanisms through which the plasma is heated, in a nuclear fusion reactor, i.e. the Neutral Beam Injection (NBI) system. An important component of a NBI system is the neutralizer of high energetic ion beams. SIPHORE proposes to substitute the gas cell neutralizer, used in the current NBI systems, with a photo-neutralizer exploiting the photo-detachment process within Fabry Perot cavities. This mechanism should allow a relevant NBI global efficiency of η> 60%, significantly higher than the one currently possible (η<25% for ITER). The present work concerns the feasibility study of an optical cavity with suitable properties for applications in NBI systems. Within this context, the issue of the determination of an appropriated optical cavity design has been firstly considered and the theoretical and experimental analysis of a particular optical resonator has been carried on. The problems associated with the high levels of intracavity optical power (~3 MW) required for an adequate photo-neutralization rate have then been faced. In this respect, we addressed both the problem of the thermal effects on the cavity mirrors due to their absorption of intra-cavity optical power (~1W) and the one associated to the necessity of a high powerful input laser beam (~1 kW) to feed the optical resonator.

We investigate the dynamic environment of the double asteroid system (65803) Didymoswith its satellite Didymos B for stable trajectories of more than 30 days for a model cubesatcalled APEX, foreseen to visit Didymos with the HERA mission, to be launched in 2023.We find semi-stable orbits with lifetimes up to 15 days under the influence of solar radiationpressure. In comparison, in the absence of solar radiation pressure, orbit trajectories reachlifetimes of up to 90 days. We present the distribution of orbital stability for positionsof initial deployment and the related orbital lifetime for inclinations of i = 0, 6 and 30 to the ecliptic plane of the sun, to investigate expected seasonality of the Didymossystem. The influence on trajectories through solar radiation pressure on the arrangementof the solar panels of APEX is compared to trajectories without solar radiation pressure. Itbecomes clear that the influence of solar radiation pressure is the main variable for stabilityof trajectories and must be further investigated with great care. We also discuss briefly theoperation of APEX in relation to orbital corrections and the limitations for such corrections.

The report shows the development during the last six months of the SMILE fluxgate magnetometer from a basic platform into a first generation magnetometer. The purpose of the SMILE project is to develop a miniaturized digital fluxgate magnetometer for the Nanospace project. The Nanospace project is collaboration by KTH and IRF Uppsala with the goal to develop a nano satellite platform. The FPGA programming has been improved to include a functional correlation loop, 13 bit DACs and a parallel and a serial interface with several output modes. The timing of the processes in the FPGA has been improved making it more robust. Some critical changes to the analogue parts has also been made. The LEMI sensors have been tested in a number of ways to increase the understanding of their characteristics. The magnetometer has also been calibrated at the Nurmijärvi geophysical observatory in Finland.

Fluxgate magnetometers have played a major role in space missions due to their stability, range of operation and low energy consumption. Their principle of operation is relatively simple and easy to implement, a nonlinear magnetic material is driven into saturation by an alternating excitation current inducing a voltage that is modulated by the external field intended to be measured. With the increasing use of nanosatellites the instruments and payload on board have been reduced considerably in size and weight. The Small Magnetometer in Low-Mass Experiment, SMILE, is a miniaturised triaxial fluxgate magnetometer with volume compensation incorporating efficient signal processing algorithms within a field programmable gate array (FPGA). SMILE was designed in collaboration between the Lviv Centre of Institute of Space Research in Ukraine where the sensor was developed and the Royal Institute of Technology (KTH) in Stockholm, Sweden where the electronics used to operate the instrument were designed and programmed. The characteristic dimensions of the SMILE magnetometer and geometry of its parts make impractical the task to find an analytical expression for the voltages induced in the pick-up coils to evaluate its performance. In this report, the results of numerical simulations of the SMILE magnetometer using a commercial finite element method (FEM) based software are presented. The results obtained are compared with the experimental data available and will serve as a first step to understand the behaviour of the nonlinear components that could lead to improvements of its design in a future.

Electrostatic waves in the form of Broadband Electrostatic Noise (BEN) have been observed in the Earth's auroral region associated with high geomagnetic activity. This broad frequency spectrum consists of three electrostatic modes, namely electron plasma, electron acoustic and beam-driven modes. These modes are excited in a plasma containing three electron components: hot, cool and beam electrons. A 1D Particle-in-Cell (PIC) simulation was developed to investigate the characteristics of the electrostatic waves found in such a plasma. Dispersion, phase space and spatial electric field diagrams were constructed from the output of the PIC simulation which were used to describe the wave dispersion and spatial field structures found in a plasma. The PIC code used a three electron component plasma with Maxwellian distributions to describe the electron velocity distributions. Beam-driven waves were found to dominate the frequency spectrum while electron plasma and electron acoustic waves are damped for a high beam velocity. Furthermore, for a high beam velocity, solitary waves are generated by electron holes (positive potentials), giving rise to a bipolar spatial electric fi eld structure moving in the direction of the beam. Increasing the beam temperature allows the beam electrons to mix more freely with the hot and cool electrons, which leads to electron plasma and electron acoustic waves being enhanced while beam-driven waves are damped. Decreasing the beam density and velocity leads to damping of beam-driven waves, while electron plasma and electron acoustic waves are enhanced. Measurements in Saturn's magnetosphere have found the co-existence of two electron (hot and cool) components. The electron velocities are best described by a kappa-distribution (instead of a Maxwellian) which has a high-energy tail. Using an adapted PIC simulation the study of electron plasma and electron acoustic waves was extended by using a kappa-distribution to describe the electron velocities with low indices. Electron acoustic waves are damped over most wave number ranges. Electron plasma waves are weakly damped at low wave numbers and damped for all other wave numbers. / <p>QC 20121205</p>

No description available.

No description available.