This degree work deals with the design and implementation of an automatic antenna tuner for short-wave transmitters. The device works within the short-wave range in (1.5 MHz - 30 MHz) band according to the selection of the given frequency. Its principle is that the tuner has a small range of adapted impedances, but it is usually sufficient for fine tuning of most deviations in the system of antenna 50 - feeder 50 - transceiver outlet 50 . It is also equipped with memories which the settings for the individual bands or frequency segments are stored into. Then the transition from one band to another is quick, easy and, first of all, safe, which is a great advantage. In automatic mode, a SWR limit from which the tuner should start to tune can be set. Interconnection with a TRX is not necessary in a fully automatic mode, the device tunes automatically after keying if the set limit of SWR has been exceeded. The automatic tuning is very quick with this device, if the antenna being tuned is not stored in the memory the tuning lasts ca 0.5 - 6 s, if the tuner uses the memory. It could be said that the work with the tuner is without problems, it is possible to learn to control it in a short time. The tuner is small and light. The result of the whole project is a compact device controlled by the user by means of push buttons.

In recent years, the demand for Li-ion-type batteries has been increasing significantly in various fields of applications including portable electronics, electric vehicles, and also in renewable energy support. These applications ask for a highly efficient charging strategy in order to maintain a long life cycle of the batteries. Recently, a new charging technique referred as sinusoidal ripple current-constant voltage charging (SRC-CV) technique has been proposed and is in certain publications claimed to realize an improved charging per-formance on Li-ion batteries than conventional constant-current constant-voltage charg-ing (CC-CV) techniques. In this thesis, the charging performance of the SRC-CV charging method applied to a prismatic Li-ion cell for an automotive traction application is inves-tigated. An existing experimental setup is upgraded to realize charging of the Li-ion cells using the SRC-CV charging method. Electrochemical impedance spectrums of three Li-ion cells have been obtained using electrochemical impedance spectroscopy (EIS). These spectrums were used to determine the charging ripple-current frequency where the mag-nitudes of the ac impedance of the cell are minimized. Key parameters like charging time, discharging time, and energy efficiency are calculated in order to compare the charg-ing performance of the CC-CV and SRC-CV charging techniques. The results reported from the experimental results obtained in this thesis indicate that there is no significant improvement with the SRC-CV charging method (implemented using a constant ripple-current frequency) compared to the CC-CV method in terms of charging time and energy efficiency. / På senare tid har behovet av batterier av Li-jontyp ökat kraftigt inom ett flertal applikationsområden inkluderande portabel elektronik, elfordon och miljövänlig elenergiproduktion. I dessa applikationsområden behövs en högeffektiv laddstrategi för att möjliggöra ett stort antal cyklingar av batterierna. Nyligen har en new laddmetod, benämnd sinusoidal ripple current-constant voltage-laddning (SRC-CV-laddning) föreslagits och har i vissa publikationer demonsterat en förbättring av laddprestanda hos Li-jonbatterier jämfört med konventionell constant-current constant-voltage-laddning (CC-CV-laddning). I detta examensarbete undersöks laddprestandan hos SRC-CV och CC-CV-laddning när de appliceras på prismatiska Li-jonceller avsedda för traktionsdrift. En existerande experimentuppsättning har uppgraderats för att realisera laddcykling med SRC-CV-laddning. Med hjälp av elektrokemisk impedansspektroskopi på tre Li-jonceller har den frekvens vid vilken magnituden på cellernas impedans är minimerad identifierats. Nyckelparametrar såsom laddtid, urladdningstid och energieffektivitet har uppmätts för både SRC-CV- och CC-CV-laddning. De experimentella resultaten visar ingen signifikant förbättring mellan SRC-CV-laddning (implementerat med en konstant rippelströmfrekvens) och konventionell CC-CV-laddning.