Perfluoroalkylated substances (PFASs) are a group of synthetic compounds that have gained growing attention due to their environmental persistence, toxicity and their potential to bioaccumulate. Even though PFASs are not occurring naturally in our environment, they are globally distributed and can be found ubiquitously in air, water, soil, wildlife as well as in humans. PFASs have primarily been used, due to their unique properties of being both hydrophilic and hydrophobic, as surfactants in numerous products such as firefighting foams, paint, leather and textile coating. The occurrence of PFASs in drinking water as well as in wastewater makes it important to develop effective techniques to remove these compounds from drinking water sources and wastewater. To be able to effectively remove PFASs from drinking water and wastewater it is important to understand which treatment process is most efficient and how the removal efficiency is affected by the physicochemical properties of PFASs and characteristics of water. In this study, the removal efficiency of PFASs was investigated using six different water types with varying dissolved organic carbon (DOC) character. Four different treatment techniques were evaluated including anion exchange using MIEX® resins, coagulation with iron (III) chloride (FeCl3), adsorption using powdered activated carbon (PAC) and nanofiltration (NF) membrane. The batch experiments were performed in laboratory-scale for 14 individual PFASs including C3-11, C13 perfluoroalkyl carboxylic acids (PFCAs), C4, C6, C8 perfluoroalkyl sulfonic acids (PFSAs) and perfluorooctane sulfonamide (FOSA). The results showed that the removal efficiency of PFASs was dependent on both perfluorocarbon chain length as well as functional group, with an increase in removal efficiency with increased perfluorocarbon chain length. Short-chained PFASs (C!6) were removed in less extent than the long chained PFASs for all treatment techniques. Amongst the four treatment techniques investigated, NF membrane exhibited the best removal efficiency for both short- and long chained PFASs (on average, 51%). Lower removal efficiencies for PFASs were observed for MIEX (33%) < FeCl3 (16%) < PAC (14%). However, all tested treatment techniques used in this study exhibited generally low removal efficiency (< 78%), in particular for the short-chained PFASs (C!6, < 41%) Results using three different doses of PAC (i.e. 20, 50, 100 mg L-1) showed an increase in removal (i.e. 2.2-41%, 8.0-78% and 12-92% respectively) with increasing dose. No significant trends were found between PFAS removal and DOC removal for any of the treatments (p<0.05, student t-test). However, the removal efficiency was different of the six different water types, which indicates that the DOC characteristics (i.e. Freshness, humification index, pH and absorbance) have an influence on the removal efficiency of PFASs in water. / Perfluoroalkylerade ämnen (PFASer) är en grupp syntetiska ämnen som har fått allt större uppmärksamhet den senaste tiden då de har visat sig vara persistenta, toxiska och bioackumulerande. Även om PFASer inte förekommer naturligt i vår miljö är de globalt fördelade och kan återfinnas i luft, vatten, mark, djur och hos människor. PFASer har främst använts, på grund av sina unika egenskaper att vara både hydrofila och hydrofoba, som tensider i många produkter såsom brandsläckningsskum, färg, läder och textil. Förekomsten av PFASer i dricksvattentäkter och i många reningsverk gör det viktigt att utveckla effektiva metoder för att ta bort dessa föreningar i vattenreningsverk. För att effektivt kunna avlägsna PFASer från dricks- och avloppsvatten är det viktigt att ha kunskap om vilken behandlingsmetod som är effektivast och hur reningseffektiviteten påverkas av ämnenas fysikalisk-kemiska egenskaper och vattnets karaktär.   Syftet med denna studie var att undersökta reningseffektiviteten för PFASer i sex olika vatten innehållande olika typer av löst organiskt kol (DOC). Detta undersöktes för fyra olika behandlingsteknikert; jonbyte med MIEX®, koagulering med järnklorid (FeCl3), adsorption med hjälp av pulveriserat aktivt kol (PAC) och nanofiltrering. Försöken gjordes små skaligt i laboratorie och 14 olika PFASer undersöktes; C3-11,13  perfluoralkyl karboxylsyror (PFCAer), C4, C6, C8, perfluoralkyl sulfonsyror (PFSAer) och perfluoroktan sulfonamid (FOSA). Resultaten visar att reningseffektiviteten för PFASer var beroende av både den perfluorerade kolkedjans längd och funktionell grupp, med en ökning av reningseffektivitet med längre perfluorerad kolkedja. PFASer med kort perfluorerad kolkedja (C≤6) renades i mindre utsträckning än PFASer med lång perfluorerad kolkedjade; detta gällde för alla behandlingstekniker. Bland de fyra behandlingstekniker som undersöktes uppvisade nanofiltreringen den bästa reningseffektiviteten för PFASer med både korta och långa kolkedjor (i genomsnitt, 51%.). Lägre reningseffektivitet för PFASer observerades för MIEX®(33%), < FeCl3(16%) < PAC (14%). Totalt sett erhölls en relativt låg reningseffektivitet (<78%) för samtliga reningstekniker, speciellt för de kortkedjade PFASer (C£6, < 41%). Resultat från försök med tre olika doser PAC (e.g. 20, 50, 100 mg L-1) visade på en ökad reningseffektivitet (2,2-41%, 8,0-78% och 12-92%) med ökad dos PAC. Inga signifikanta trender kunde urskiljas vad gäller reningseffektivitet av PFASer och rening av DOC (p<0.05, student t-test), detta gällde för samtliga behandlingstekniker. Det fanns dock tydliga skillnader i reningseffektivitet mellan de sex olika vattentyperna vilket indikerar på att DOC egenskaperna (Freshnessindex, humifieringsindex, pH, absorbans) har en påverkan på reningseffektiviteten för PFASer i vatten.

Conselho Nacional de Desenvolvimento Científico e Tecnológico / This work reports the synthesis of a series of 4-organoselenyl-isoxazoles (19 examples), prepared via FeCl3/diorganyl diselenides-promoted intramolecular cyclization of alkynone O-metyloximas. In general, the selenyl-isoxazoles were obtained, in 50 to 70% yield. In addition, an alternative method was developed to promote the intramolecular cyclization reaction of o-alkynyl-N,N-dimethyl-anilines, where FeCl3 and substituted diorganyl diselenides were employed as promoter agents to this process. Through this cyclization protocol a series of N-methyl-3-organoselenyl-indoles could be synthesized (20 examples), in yields varying from 36 to 81%, by using room temperature and ambient atmosphere. In order to evaluate the versatility of the obtained compounds as precursors to the synthesis of functionalized isoxazoles and indoles, the 3,5-diphenyl-4-(phenylselenyl)-isoxazole, N-methyl-2-phenyl-3-(phenylselenyl)-1H-indole and N,5-dimethyl-2-phenyl-3-(phenylselenyl)-1H-indole were submitted to PhSe-Lithium exchange reactions, and the corresponding organolithium intermediates, which were generated by treatment with nBuLi, could be trapped with different electrophiles, affording the functionalized isoxazoles (5 examples) and indoles (4 examples) in good yields (45-80%). / Este trabalho relata a síntese de uma série de 4-organoseleno-isoxazóis (19 exemplos), preparados a partir da reação de ciclização intramolecular de O-metiloximas alquinílicas promovidas por FeCl3 e diferentes disselenetos de diorganoíla. Em geral, os derivados de seleno-isoxazóis foram obtidos de maneira satisfatória, em rendimentos de 50 a 70%. Desenvolveu-se também, um método alternativo para promover a reação de ciclização intramolecular de o-alquinil-N,N-dimetil-anilinas, empregando-se FeCl3 e disselenetos de diorganoíla diferentemente substituídos, como agentes promotores da ciclização. Através deste protocolo de ciclização pode-se sintetizar uma série de N-metil-3-organosseleno-indóis (20 exemplos), em rendimentos que variaram de 36 a 81%, utilizando condições de reação brandas, uma vez que os experimentos foram realizados a temperatura e atmosfera ambiente. A fim de avaliar a versatilidade dos compostos obtidos, como precursores para a síntese de isoxazóis e indóis com diferentes funcionalizações, o 3,5-difenil-4-(fenilselenil)-isoxazol e o N-metil-2-fenil-3-(fenilselenil)-1H-indol e N,5-dimetil-2-fenil-3-(fenilselenil)-1H-indol, foram submetidos à reações de troca PhSe-lítio, e o intermediário litiado correspondente, formado a partir de uma reação utilizando n-BuLi, pôde ser capturado com diferentes eletrófilos, obtendo-se como produtos uma série de isoxazóis (5 exemplos) e indóis (4 exemplos) diferentemente funcionalizados em bons rendimentos (45-80%).

L’accès par voie chimique à des oligosaccharides nécessite souvent le recours à de nombreuses étapes de protection-déprotection. Au cours de ce projet de thèse, une méthodologie pour la protection régiosélective et orthogonale des fonctions alcool de disaccharides dérivant de la biomasse a tout d’abord été développée. Les glycopyranosides protégés ont été préparés par catalyse tandem au FeCl3∙6H2O en réalisant dans le même pot des réactions d’acétalation, d’éthérification réductrice, d’acétylation et/ou d’ouverture réductrice régiosélective d’acétals. Dans un second temps, une stratégie de synthèse flexible, rapide et performante pour accéder à des sulfoglycolipides diacylés et tétraacylés comportant un cœur tréhalose a été mise au point. Ces molécules sont produites par Mycobacterium tuberculosis, l’agent pathogène responsable de la tuberculose, et les sulfoglycolipides diacylés pourraient permettre l’élaboration d’un nouveau vaccin contre cette maladie. Des sulfoglycolipides diacylés et tétraacylés comportant des chaînes monométhylées chirales ont été obtenus. Les précurseurs des acides gras chiraux utilisés au cours de la synthèse ont été analysés par spectroscopie RMN du deutérium en abondance naturelle dans des cristaux liquides chiraux. / The synthesis of oligosaccharides often requires long sequences of protection-deprotection steps. For a rapid access to suitably protected glycopyranosides, we have developed a one-pot regioselective protection strategy based on FeCl3∙6H2O-tandem catalyzed reactions (acetalation, acetylation, reductive etherification, regioselective ring opening of acetal). This procedure was applied to persilylated disaccharides derived from biomass. This methodology allowed the development of a fast, efficient and flexible access to diacylated and tetraacylated sulfoglycolipids based on a trehalose core. These molecules are found in the cell wall of Mycobacterium tuberculosis and the diacylated sulfoglycolipids appear to be promising candidates for the development of a new tuberculosis vaccine. Synthetics diacylated and tetraacylated sulfoglycolipids bearing chiral monomethylated fatty chains were produced. The chiral fatty-acid precursors, used in the procedure, were synthetized and analyzed by NMR spectroscopy of natural abundance deuterium in chiral liquid crystals.