No description available.

Permanent magnet synchronous machine drives are used more often. Although, synchronous machines drive also suffer from possible faults. This thesis is focused on the detection of the three-phase synchronous motor winding faults and the detection of the drive control loop sensors' faults. Firstly, a model of the faulty winding of the motor is presented. Effects of the inter-turn short fault were analyzed. The model was experimentally verified by fault emulation on the test bench with an industrial synchronous motor. Inter-turn short fault detection algorithms are summarized. Three existing conventional winding fault methods based on signal processing of the stator voltage and stator current residuals were verified. Three new winding fault detection methods were developed by the author. These methods use a modified motor model and the extended Kalman filter state estimator. Practical implementation of the algorithms on a microcontroller is described and experimental results show the performance of the presented algorithms in different scenarios on test bench measurements. Highly related motor control loop sensors fault detection algorithms are also described. These algorithms are complementary to winding fault algorithms. The decision mechanism integrates outputs of sensor and winding fault detection algorithms and provides an overall drive fault diagnosis concept.

This thesis deals with the elaboration of The Permanent Magnet Synchronous Motor and the calculation of its parameters. In the first part, the construction and used permanent magnets of this motor are listed here. The next part of the thesis contains a short overview of the stator windings, the calculation of the winding factors and calculation of the basic parameters of the stator winding. The calculation of the magnetic induction in the air gap is also illustrated here. The result is recalculated by using the Carter factor and then the value of the first harmonics of air-gap flux density is determined. The result is compared with the analysis in the program FEMM. The next part of the thesis is creating a comprehensive overview of the machine using a replacement circuit diagram and phasor diagrams. Finally, the thesis contains model created in RMxprt and ANSYS Maxwell. The results of the model analysis are compared with the analytical calculation

Master thesis deals with design and construction of the most widely used engines currently. Overall, it is divided into five chapters, the first chapter deals with constructional features of various three-phase asynchronous motors, the second chapter briefly paid attention to single-phase motors. The next chapter focuses on the specific engine types, which differ from standard induction motors in its design implementation. This is an engine with full rotor, hysteresis, linear and with shaded field. Although asynchronous motors are considered the most reliable machines work in imperfect conditions, it leads to frequent breakdowns. This is covered in chapter four. Based on the findings from previous chapters the fifth chapter includes a preliminary draft of the asynchronous motor with a full rotor. The last chapter is devoted to the measurement on functional models.