Spelling suggestions: "subject:"polyethyleneterephthalate"" "subject:"polyethylenterephthalate""
1 |
Structural development of polyethylene terephthalate (PET) through solid-state drawing and annealingLeung, Ka-po, Filipe., 梁嘉保. January 2003 (has links)
published_or_final_version / Mechanical Engineering / Master / Master of Philosophy
|
2 |
Fibres from recycled post consumer PET/nylon 6 blendsKegel, Mark. January 2006 (has links)
Thesis (PhD) - Swinburne University of Technology, Industrial Research Institute Swinburne - 2006. / A thesis submitted to Industrial Research Institute Swinburne in fulfilment of the requirements for the degree of Doctor of Philosophy, Swinburne University of Technology - 2006. Typescript. "July 2006". Includes bibliographical references (p. 147-156).
|
3 |
Synthesis and characterisation of branched poly(ethylene terephthalate)sNeilson, Alan Finlay January 1999 (has links)
This report details the work carried out on the synthesis and characterisation of branched polyesters. The experimental effort concentrated on the branching of PET-type polymers with a variety of potential branching agents, such as trimesic acid, and the control of branching with end-capping agents, such as benzyl alcohol. The polymers synthesised were then characterised by solution viscosity, end-group analysis, DSC analysis, theological analysis and light scattering. Extensive branching of polymers has been observed and controlled via end-capping agents. One group of polyesters synthesised with increasing levels of brancher, were characterised by absolute Mw values which increased from -10K to -350K. Despite this, all of the macromolecules displayed roughly the same solution viscosity. Though the corresponding melt viscosity increased with Mw, the values achieved were far below those expected for analogous linear polymers of comparable Mw. A second group of polyesters synthesised with a fixed level of brancher and increasing levels of end-capper were characterised by a much narrower range of Mw values. These polymers however had melt viscosities lower than those of linear polymers yet had Mw's of between -3 and - 15 times greater than those of linear polymers.
|
4 |
Surface structure of oriented PET filmsKirov, Kiril January 2001 (has links)
No description available.
|
5 |
Dielectric loss of stretched polyethyleue terephthalate.January 1974 (has links)
Thesis (M. Phil.)--Chinese University of Hong Kong. / Bibliography: leaves 37-38.
|
6 |
New comonomers and pet-based copolymers for functional high-barrier applicationsAndrade, Genara Selene 05 1900 (has links)
No description available.
|
7 |
Analysis of poly(ethylene terephthalate) fibers using polarized raman microscopyYang, Shuying January 2002 (has links)
No description available.
|
8 |
Surface properties of poly(ethylene terephthalate) /Matthews, Thomas R. January 2007 (has links)
Thesis (M.S.Ch.E.)--University of Toledo, 2007. / Typescript. "Submitted as partial fulfillment of the requirements for The Masters of Science Degree in Chemical Engineering." Bibliography: leaves 76-77.
|
9 |
Sorption and transport of gases and organic vapors in poly(ethylene terephthalate)Dhoot, Sushil Naresh, Freeman, B. D. January 2004 (has links) (PDF)
Thesis (Ph. D.)--University of Texas at Austin, 2004. / Supervisor: Benny D. Freeman. Vita. Includes bibliographical references.
|
10 |
Light scattering studies of the crystallization of polyethylene terephthalate.Yuasa, Takeo 01 January 1975 (has links) (PDF)
No description available.
|
Page generated in 0.0599 seconds