No description available.

No description available.

This master thesis deals with the issue of production of wooden toy in the company Detoa Albrechtice. The aim was to prepare an analysis of the current state of the company, including a description of the existing production proces. Based on this analysis, it was designed several variants of possible solutions. Because of the scope of work has been chosen one optimal solution. This option in more detail processed. The thesis also includes an option to extend the range of existing production The results obtained are shortly economic evaluation.

This diploma work analyses technology documentation, material manipulation, machines and manipulation devices in its first part. Aim of this analyse is detection present entire lacks of manipulation state. Diploma work suggests options of solution to determinate entire lacks of manipulation in its second part and elaboration of chosen option.

The aim of this work is to rationalize the production process of the components produced by the actuator AVEKO Ltd. By analyzing the current state of identified weaknesses and proposals for amendments were made to increase volume and production efficiency. The following amendment has been prepared an economic evaluation and overall evaluation of the work.

In the introductory part of the thesis, there is a description of machining technologies used in the production of body. This is followed by a detailed analyse of the current technology of production of this component with an emphasis on finding its problematic parts, including a proposal of the options of the rationalization. After the methods of rationalization assesment, a new technological process was developed and the alternative tools were proposed. Considerable time and money savings were achieved by this rationalization. In the discussion section, there were designed some options of solving problems arising during the installation of this rationalization into working.

The thesis is focused on the rationalization of the grinding body production as a special accessory for a vertical lathe with the type designation BASICTURN 1250 from the company TOSHULIN PLC. The thesis describes the problems of the current production and suggests the constructional and technological adjustments in order to achieve a reduction of the production costs and the overall production efficiency.

The doctoral thesis deals with the cost rationalization in the process of small electric machines production. The rationalization can be done on two different levels: technical and economic. The doctoral thesis is divided into two parts, each focusing on the particular level and describing the production processes in which it is possible to optimize the costs. The main part of the doctor thesis concentrates on the economic side of the problém. It presents and analyses the origin of the costs, their identification and classification.Production costs specification and calculation are analysed. Due to the fact that there are many possibilities of optimal production cost calculations used in the process of small electric machines production, much attention is devoted to possibile calculation methods and calculation formulas.

This master's thesis deals with the process of machining a forged connecting rod in cooperation with the company Zetor Tractors a.s. The first chapter of the thesis is focused on a detailed introduction of the company. The second chapter includes an elaborate analysis of the technical documentation and requirements concerning the making process of the subject of study, specifically the construction of the connecting rod. In the third chapter, the current production technology is discussed and described in detail. The aim of the fourth chapter is to propose an innovative technology which can be used for the production of connecting rods in the required quality. The fifth chapter is aimed at testing the newly designed technology. In the final, sixth, chapter, a technical and economical evaluation of the proposed procedure is performed.

The assigned thesis is focused on the proposal of rationalization solutions to the component Bonnet, which is a standard representative of the most important sections of broader spectrum of customer´s components. The introduction part describes the component basis, according to which the standard representative was chosen, later on characterised from the point of view of seriality. The following large part of classfying the time comsumption in machinery is essential for the calculations as such, which are the essential part of this dissertation. The proposal of production rationalization is concerned with the exclusion of unnecessary losses and using existing ressources with the help of a higher level of machinery, technology, work organisation, production and management, which lead to a higher labour productivity. The technological production preparation ensures the documentation processing, the proposal of semi-finished product, machines, fastening, measuring and calculation of necessary technological specifications for ensuring the production. In the final part, there is to be found the technical and economical evaluation of rationalization proposals, which numerically evaluates the analysed outputs of this thesis.