Low temperature sintering has become a very important research area in ceramics processing and sintering as a promising process to obtain grain size below 100nm. For electronic ceramics, low temperature sintering is particularly difficult, because not only the required microstructure but also the desired electronic properties should be obtained. In this dissertation, the effect of liquid sintering aids and particle size (micrometer and nanometer) on sintering temperature and Positive Temperature Coefficient Resistivity (PTCR) property are investigated for Ba1-xSrxTiO3 (BST) doped with 0.2-0.3mol% Sb3+ (x = 0.1,0.2,0.3,0.4 and 0.5). Different sintering aids with low melting point are used as sintering aids to decrease the sintering temperature for micrometer size BST particles. Micrometer size and nanometer size Ba1-xSrxTiO3 (BST) particles are used to demonstrate the particle size effect on the sintering temperature for semiconducting BST. To reduce the sintering temperature, three processes are developed, i.e. 1 using sol-gel nanometer size Sb3+ doped powders with a sintering aid; 2 using micrometer size powders plus a sintering aid; and 3 using nanometer size Sb3+ doped powders with sintering aids. Grain size effect on PTCR characteristics is investigated through comparison between micrometer size powder sintered pellets and nanometer size powder sintered pellets. The former has lower resistivity at temperatures below the Curie temperature (Tc) and high resistivity at temperatures above the Curie temperature (Tc) along with higher ñmax/ñmin ratio (ñmax is the highest resistivity at temperatures above Tc, ñmin is the lowest resistivity at temperatures below Tc), whereas the latter has both higher ñmax and ñmin. Also, ñmax/ñmin is smaller than that of pellets with larger grain size. The reason is that the solid with small grain size has more grain boundaries than the solid with large grain size. The contribution z at room temperature and high temperature and a lower ñmax/ñmin ratio value.

Before beginning the experimental work of this study, a magnesium high pressure die casting facility is set up to manufacture magnesium cast parts for defence industry. In this thesis two components are cold chamber high pressure die casted using magnesium alloy AZ91 as raw material, and one component was manufactured using both aluminium alloy A.413, and magnesium alloy AZ91. Mechanical properties of high pressure die casting parts depend on various parameters such as, thickness of the cast part, position of the cast part in the cavity, molten metal temperature, die temperature, piston speeds, and injection pressure. The aim of this study is to investigate the effects of section thickness of the cast part, position of the cast part in the die cavity, piston speeds, and molten metal temperature on mechanical properties of magnesium die cast parts. Tensile properties of products from Al A.413 and Mg AZ91 alloys are also compared. Casting analysis software is used to simulate filling and temperature evolution of three different casting components. Piston speeds are first calculated from equations in the literature and then verified by using the software. Specimens for microstructural investigation, and mechanical tests are machined directly from the mass produced parts. Optical microscopy, and scanning electron microscopy investigations are carried out for grain size and porosity determination. Tensile tests are conducted for yield strength, ultimate tensile strength, and % elongation values. The results of casting analysis software simulations, grains size investigations, porosity investigations, and tensile tests are correlated to each other. Optimum piston speeds, optimum molten metal temperatures are observed, effect of grain size and porosity concentrations on the effect of mechanical properties are compared. Weight of cast parts produced from Mg AZ91 are 35 % lower than that of Al A.413 parts. However, ultimate tensile strength of the cast parts produced from Mg AZ91 are found to be similar to the aluminium parts.