In resonant earthed distribution systems, the capacitive current of the system is compensated by grounding via a arc suppression coil. The level of fault current is then very small and independent on the fault location which greatly complicates the rapid finding of the fault site. At this moment there is no method to be used to directly locate the site of a single-phase fault in the distribution network, new methods and solutions are being constantly sought to address the shortcomings of the existent localization methods. The diploma thesis deals with the design of a universal software tool that allows to apply a new method of locating an asymmetric fault in the distribution network. The tool is created in a MATLAB environment and utilizes the negative sequence voltage measured on the low-voltage sides of the distribution transformers and the negative sequence current measured behind the power transformer. By using the proposed tool, it is possible to read the parameters of any part of the distribution system that the user enters together with the measured values of the voltage and current into the initialization file. After the specified network parameters are loaded, a numerical model is created, which is then used for the method. In the work is described in detail the way of entering the parameters of the network into the initialization file, the method of automatic assembling of the numerical model based on the entered data and the possibility of customizing the calculation parameters. At the end of the thesis, the functionality of the proposed software tool is verified on data from simulation of the test network.

Basic problems of the EMI mains filter is explained in the introduction of this thesis. These problems appear during the measurement of insertion loss of filters and by design of EMI mains filter. The important problem is uncertainly of the terminating impedances. Eventualities measurement insertion loss of EMI mains filter and motivation of creation filter models are shown. The following part of this project shows the electronic components, from which are realized the EMI mains filter. Parasitic properties of these real devices are also discussed. The circuitry of EMI mains filter is described by the Modified Nodal Voltage Method. The optimization method called Participle Swarm Optimization is introduced, too. Basic principle and terminology are mentioned. The third part of this project is focused on the own filter and spurious components. Influence of own filter and spurious filters components on insertion loss curve are showed. Magnetic factor coefficient k is searched by the optimization method PSO. The last part of this thesis deals with creation of the alternative circuits with spurious filters components. The performances of the alternative circuits were compared with the measured data for symmetrical and asymmetrical measurement setup. The breakages in the insertion loss curve were used for determining the spurious components.