Motivation: The accurate and reliable measurement of the concentration of coal tar pitch volatiles (CTPVs) in ambient air has proved to be a challenge for occupational hygienists. The challenge must however be confronted due to, amongst others, the carcinogenic properties of some poly–aromatic hydrocarbons (PAHs) contained in CTPVs. Aim: To determine the feasibility of a thermal desorption (TD) technique based method as an alternative method to be used for the measurement of the concentration of CTPVs in ambient air by assessing it along criteria such as ease of use, cost, accuracy and precision by comparing it to NIOSH’s Method 5515 and OSHA’s Method 58 and to determine the level of exposure to CTPVs on the anode paste floor of an electric furnace, used for the smelting of platinum group metals (PGMs) concentrate. Methodology: To satisfy the research objective, two accepted methods the National Institute of Occupational Safety and Health’s (NIOSH) method 5515 and the Occupational Safety and Health Administration’s (OSHA) method 58 were used for the measurement of the concentration of CTPVs with a TD technique based method used as a third, alternative method. All three methods were used concurrently to measure the concentration of CTPVs in ambient air, at the anode paste floor of a platinum group metals (PGMs) concentrate smelter. Results and conclusions: The NIOSH method proved to be the most precise method while the TD technique based method proved to be the most accurate. The TD technique based method proved to measure the widest range of individual CTPVs and were able to measure the highest concentration of Benzo(a)pyrene, an individual CTPV that is classified as a Group 1 (carcinogenic to humans) chemical substance by the International Agency for Research on Cancer (IARC). The OSHA method measured on average almost four times less total CTPVs than either the NIOSH or the TD technique based method and failed to readily measure individual CTPVs with a molecular weight lower than that of Phenanthrene. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2012.

Motivation: The accurate and reliable measurement of the concentration of coal tar pitch volatiles (CTPVs) in ambient air has proved to be a challenge for occupational hygienists. The challenge must however be confronted due to, amongst others, the carcinogenic properties of some poly–aromatic hydrocarbons (PAHs) contained in CTPVs. Aim: To determine the feasibility of a thermal desorption (TD) technique based method as an alternative method to be used for the measurement of the concentration of CTPVs in ambient air by assessing it along criteria such as ease of use, cost, accuracy and precision by comparing it to NIOSH’s Method 5515 and OSHA’s Method 58 and to determine the level of exposure to CTPVs on the anode paste floor of an electric furnace, used for the smelting of platinum group metals (PGMs) concentrate. Methodology: To satisfy the research objective, two accepted methods the National Institute of Occupational Safety and Health’s (NIOSH) method 5515 and the Occupational Safety and Health Administration’s (OSHA) method 58 were used for the measurement of the concentration of CTPVs with a TD technique based method used as a third, alternative method. All three methods were used concurrently to measure the concentration of CTPVs in ambient air, at the anode paste floor of a platinum group metals (PGMs) concentrate smelter. Results and conclusions: The NIOSH method proved to be the most precise method while the TD technique based method proved to be the most accurate. The TD technique based method proved to measure the widest range of individual CTPVs and were able to measure the highest concentration of Benzo(a)pyrene, an individual CTPV that is classified as a Group 1 (carcinogenic to humans) chemical substance by the International Agency for Research on Cancer (IARC). The OSHA method measured on average almost four times less total CTPVs than either the NIOSH or the TD technique based method and failed to readily measure individual CTPVs with a molecular weight lower than that of Phenanthrene. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2012.

Objectives: The aim of this study was to determine if exposure to volatile organic compounds can lead to DNA damage and impaired DNA repair capacity. Nail cosmetics is a fast growing industry around the world where employees and clients are subjected to various chemical substances which may be harmful to their health: such as formaldehyde, toluene, acetone, xylene, ethylmethacrylate, methylmethacrylate and n–buthyl acetate. These chemicals have the potential to be harmful to their health and exposure to these chemicals should be actively controlled. Formaldehyde is classified as a human carcinogen by the IARC, whereas, toluene and xylene are group three carcinogens, classified in 1999 (not classified as carcinogenic to humans), and various studies have linked DNA damage and impaired DNA repair to the above mentioned substances. Methods: Fifteen nail technicians were monitored by means of personal air sampling, measuring formaldehyde, toluene, xylene, acetone and ethylmethacrylate exposure. Fifteen unexposed subjects were chosen and matched for age and smoking habits with the exposed group. Heparinised blood samples were obtained from each test subject with which the Comet Assay was performed on lymphocytes to determine DNA damage and repair ability. Results: Exposure to ethylmethacrylates and methylmethacrylates leads to DNA damage. Methylmethacrylate causes DNA damage by specifically targeting pyrimidine (fpg) bases. N–buthyl acetate, xylene and acetone exposure impaired DNA repair capacity. The exposed group showed signs of Class III and Class IV DNA damage, whereas the control group had little Class III damage and no indication of Class IV damage. The overall DNA repair ability of the nail technicians was slightly impaired when compared to that of the control group, which is in concurrence with previous studies. Smoking habits and age did not show significant influences on the level of DNA damage and repair when compared with the control group. Conclusion: Exposure to volatile organic compounds such as ethylmethacryale and methylmethacrylate may lead to DNA damage and altered DNA repair in some individuals, although further studies are recommended. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2011.

Objectives: The aim of this study was to determine if exposure to volatile organic compounds can lead to DNA damage and impaired DNA repair capacity. Nail cosmetics is a fast growing industry around the world where employees and clients are subjected to various chemical substances which may be harmful to their health: such as formaldehyde, toluene, acetone, xylene, ethylmethacrylate, methylmethacrylate and n–buthyl acetate. These chemicals have the potential to be harmful to their health and exposure to these chemicals should be actively controlled. Formaldehyde is classified as a human carcinogen by the IARC, whereas, toluene and xylene are group three carcinogens, classified in 1999 (not classified as carcinogenic to humans), and various studies have linked DNA damage and impaired DNA repair to the above mentioned substances. Methods: Fifteen nail technicians were monitored by means of personal air sampling, measuring formaldehyde, toluene, xylene, acetone and ethylmethacrylate exposure. Fifteen unexposed subjects were chosen and matched for age and smoking habits with the exposed group. Heparinised blood samples were obtained from each test subject with which the Comet Assay was performed on lymphocytes to determine DNA damage and repair ability. Results: Exposure to ethylmethacrylates and methylmethacrylates leads to DNA damage. Methylmethacrylate causes DNA damage by specifically targeting pyrimidine (fpg) bases. N–buthyl acetate, xylene and acetone exposure impaired DNA repair capacity. The exposed group showed signs of Class III and Class IV DNA damage, whereas the control group had little Class III damage and no indication of Class IV damage. The overall DNA repair ability of the nail technicians was slightly impaired when compared to that of the control group, which is in concurrence with previous studies. Smoking habits and age did not show significant influences on the level of DNA damage and repair when compared with the control group. Conclusion: Exposure to volatile organic compounds such as ethylmethacryale and methylmethacrylate may lead to DNA damage and altered DNA repair in some individuals, although further studies are recommended. / Thesis (M.Sc. (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2011.