Battery charging wind turbines like, Hybrid Field Generator, have become more popular in the growing renewable energy market. With wind energy, voltage and current control is generally provided by means of power electronics. The paper describes the analytical investigation in to control aspects of a hybrid field generator controller for optimized performance. The project objective is about maintaining the generated voltage at 28V through out a generator speed range, between 149 rpm and 598 rpm. The over voltage load, known as dump load, is connected to the control circuit to reduce stress on the bypass transistor for speeds above 598 rpm. Maintaining a stable voltage through out the speed range, between 149rpm and 598rpm, is achieved by employing power electronics techniques. This is done by using power converters and inverters to vary the generator armature excitation levels hence varying its air gap flux density. All these take place during each of the three modes of generator operation, which are: buck, boost and permanent magnet modes. Although the generator controller is power electronics based, it also uses software to optimize its performance. In this case, a PIC16F877 microcontroller development system has been used to test the controller function blocks.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:nmmu/vital:10818 |
| Date | January 2003 |
| Creators | Moleli, Christopher Teboho |
| Publisher | Port Elizabeth Technikon, Faculty of Engineering |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis, Masters, MTech (Electrical Engineering) |
| Format | xviii, 210 leaves, pdf |
| Rights | Nelson Mandela Metropolitan University |
Page generated in 0.0018 seconds