Return to search

Dynamic Modeling of a Supersonic Tailless Aircraft with All-moving Wingtip Control Effectors

A six degree-of-freedom model for a tailless supersonic aircraft (TSA) concept was developed using MATLAB and Simulink. Aerodynamic data was provided through the computational fluid dynamics analysis of Techsburg, Inc. A three degree-of-freedom model of the configuration's longitudinal dynamics was completed first. Elevator control power was derived from the dynamic response requirements for pitch chosen by Techsburg. The propulsion model utilized General Electric F-414-400-like turbofan engines because an engine deck was readily available. Work on the six degree-of-freedom dynamic model began with determining the necessary rolling and yawing moment coefficients necessary to meet the rest of the chosen dynamic response requirements. These coefficients were then used to find the corresponding all-moving tip deflections. The CFD data showed that even at small all-moving tip deflections the rolling moment coefficient produced was much greater than the amount of yawing moment coefficient produced. This result showed that an additional roll effector was needed to counteract excess rolling moment at any given all-moving tip deflection and trim the aircraft. An angle of attack and pitch rate feedback controller was used to improve the longitudinal dynamics of the aircraft. Because this configuration lacked a vertical tail, a lateral-directional stability augmentation system was vital to its success. The lateral-directional dynamics were improved to Level 1 flying qualities through use of a modified roll/yaw damper. The modified controller fed yaw rate back to both the all-moving tips and roll effector. The six degree-of-freedom model was augmented with actuator dynamics for the elevator, roll effector, and all-moving tips. The actuators were modeled as first order lags. The all-moving tip actuator time constant was varied to determine the effect of actuator bandwidth on the lateral-directional flying qualities. After the actuator dynamics were successfully implemented, the six degree-of-freedom model was trimmed for both standard cruise and engine-out situations. The eccentuator concept from the DARPA Smart Wing program was selected as a possible conceptual design for the all-moving tip actuation system. The success of the TSA six degree-of-freedom dynamic model proved that morphing all-moving tips were capable of serving as effective control surfaces for a supersonic tailless aircraft. / Master of Science

Identiferoai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/36047
Date19 December 2007
CreatorsWhite, Brady Alexander
ContributorsAerospace and Ocean Engineering, Mason, William H., Woolsey, Craig A., Hall, Christopher D., Inman, Daniel J.
PublisherVirginia Tech
Source SetsVirginia Tech Theses and Dissertation
Detected LanguageEnglish
TypeThesis
Formatimage/jpeg, application/pdf, image/jpeg, image/jpeg
RightsIn Copyright, http://rightsstatements.org/vocab/InC/1.0/
RelationBrady_White_-Copyright_Permissions-Sage_Publications_(1).jpg, Brady_White-MS_Thesis.pdf, Brady_White-Copyright_Permissions-Techsburg_Inc..jpg, Brady_White-Copyright_Permissions-Sage_Publications_(2).jpg

Page generated in 0.002 seconds