This thesis demonstrates the effective use of low temperature molecular beam epitaxy to encapsulate planar Si:P (phosphorus-in-silicon) devices lithographically patterned by scanning tunnelling microscopy (STM) without significant redistribution of the dopants. To achieve this goal, low temperature magnetotransport is used in combination with STM, Auger electron spectroscopy and secondary ion-mass spectrometry to analyse Si:P ??-doped samples fabricated under different doping and growth conditions. An important aspect of this project is the use of large 1 ?? 1 cm2 Si(001) samples which are about five times larger than standard STM samples. The larger sample size is necessary for post-STM fabrication lithography processes in a cleanroom but presents problems for preparing atomically clean surfaces. The ability to prepare clean and atomically flat Si(001) surfaces for STM lithography on such 1 ?? 1 cm2 samples is demonstrated, and it is shown that Si:P ??-doped layers fabricated on these surfaces exhibit complete electrical activation. Two dopant sources (gaseous PH3 and solid GaP source) were investigated to assess their compatibility with STM-lithography on the H:Si(001) surface. The findings show that while the PH3 and GaP sources result in near identical electrical qualities, only PH3 molecules are compatible with H-resist based lithography for controlled nano-scale doping. For achieving complete activation of the P dopants, it is shown that an anneal to ??? 350 ???C to incorporate P atoms into the Si surface prior to encapsulation is critical. While it is known that the presence of H during growth degrades the quality of Si epitaxy, investigations in this thesis indicate that it has no significant effect on dopant activation. Systematic studies performed to assess the impact of growth temperature recommend an encapsulation temperature of 250 ???C for achieving optimal electrical qualities with minimal dopant segregation. In addition, it is shown that rapid thermal anneals (RTAs) at temperatures < 700 ???C provide only marginal improvement in the electrical quality of Si:P ??-doped samples encapsulated at 250 ???C, while RTA temperatures > 700 ???C should be avoided due to the high probability of dopant redistribution. To elucidate the nature of 2D transport in Si:P ??-doped devices, a detailed analysis of the low temperature magnetotransport for Si:P ??-doped layers with doping densities in the range ??? 0.2 ??? 2 ?? 1014 cm???2 was carried out. Using conventional 2D theories for disordered systems, both weak localisation (WL) and electron-electron interactions (EEI) are shown to contribute almost equal corrections to the 2D conductivity. In particular, it is found that EEI can introduce a significant correction in the Hall coefficient RH (hence Hall density) especially in the low density/temperature regime and the need to correct for this when using the Hall density to estimate the activated electron density is highlighted. While the electronic mean free path in such highly doped ??-layers is typically < 10 nm making ballistic transport in these devices difficult to observe, the phase coherence length can extend to almost 200 nm at about 0.3???0.5 K for doping densities of ??? 1 ??? 2 ?? 1014 cm???2. Finally, the optimised encapsulation strategy developed in this thesis is applied to a 2D square device fabricated by STM. The device exhibits Ohmic conductivity with complete dopant activation. An analysis of its low temperature magnetotransport shows that the device behaves similarly to a Si:P ??-doped layer encapsulated under similar conditions, thus highlighting that the STM patterning process had no adverse effect on device quality.
| Identifer | oai:union.ndltd.org:ADTP/257228 |
| Date | January 2006 |
| Creators | Goh, Kuan Eng Johnson, Physics, Faculty of Science, UNSW |
| Publisher | Awarded by:University of New South Wales. School of Physics |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | Copyright Kuan Eng Johnson Goh, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0021 seconds