Statement of Problem
There are limited studies evaluating the effect of a cyclic load on interim fixed prosthetic materials and its effect on flexural strength.
Purpose of Study
1) To verify the flexural strength of previously studied interim fixed prosthetic materials.
2) To establish the flexural strength of new, advanced generation and untested interim fixed prosthetic materials.
3) To determine the effect of cyclic load on the flexural strength of interim fixed prosthetic materials.
Materials and Methods
Bar-type specimens of Caulk Temporary Bridge Resin, VitaVM CC, Protemp 3 Garant and Radica were fabricated according to International Standards Organization 4049 and American National Standards Institute/American Dental Association specification 27. After being stored in distilled water for 10 days, specimens were divided into Noncycled and Cycled Groups. The Noncycled Group specimens were fractured under a 3-point loading in a Bose Electroforce 3300 testing instrument at a crosshead speed of 0.75 mm/min. Cycled Groups specimens underwent a 6-12 Newton 3 Hertz cyclic load for 20,000 cycles in a Bose Electroforce 3300 testing instrument. Immediately following completion of the cycles, the specimens were fractured under a 3-point loading. Maximal loads to fracture in Newtons were recorded and mean flexural strengths were calculated (n = 20 per group). Comparisons were made with analysis of variance and Tukey's Multiple Comparison Test.
Results
Noncycled (NC) and Cycled (C) groups order of mean flexural strengths (MPa) from lowest to highest mean were as follows: Caulk (Noncycled - 53.83; C - 60.02), Vita VM CC (NC - 65.96; C - 66.83), Protemp 3 Garant (NC - 75.85; C - 77.18), and Radica (NC - 106.1; C - 115.96). In the Noncycled and Cycled groups, Radica was statistically superior when compared to all materials and Protemp 3 Garant was statistically superior to Caulk Temporary Bridge Resin. There was no statistically significant difference between the material's flexural strengths before and after cycles.
Conclusion
Within the limitations of this study, 20,000 cyclic loads of 6-12 Newtons at 3 Hertz did not have a significant effect on the flexural strength of interim fixed prosthetic materials. Radica demonstrated significantly superior flexural strength over other materials tested.
Identifer | oai:union.ndltd.org:uiowa.edu/oai:ir.uiowa.edu:etd-1562 |
Date | 01 December 2009 |
Creators | Heying, Jamie John |
Contributors | Gratton, David G. |
Publisher | University of Iowa |
Source Sets | University of Iowa |
Language | English |
Detected Language | English |
Type | thesis |
Format | application/pdf |
Source | Theses and Dissertations |
Rights | Copyright 2009 Jamie John Heying |
Page generated in 0.002 seconds