The energy requirements of forage harvesters can be quite high and can sometimes determine the size of tractor needed on a farm. Therefore, improving the energy efficiency of the forage harvester could allow a farm to reduce costs by using a smaller tractor that is less expensive and more efficient. The objective of this research was to increase the throwing distance of a forage harvester by modeling the flow of forage in the spout and the air flow in the blower and spout. These models can then be used to compare the efficiencies of prototype designs.
The air flow in the blower and spout was modeled using the commercial computational fluid dynamics software FLUENT. The simulation results of air velocities and flow patterns were compared to experimental values and it was found that both were of the same order of magnitude with the model predicting slightly higher air velocities than those measured.
The flow of forage in the spout was modeled analytically by taking into account the friction between the forage and the spout surface and the aerodynamic resistance after the forage leaves the spout. From this model, two improved prototype spouts that should theoretically result in longer throwing distances were designed. However, field testing of the two prototypes did not reveal any significant improvements over the current design. It was also found that the model under-predicted the throwing distance of one prototype by 2 % and over estimated the other by 12 %.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:SSU.etd-07282005-163454 |
| Date | 29 July 2005 |
| Creators | Lammers, Dennis Peter |
| Contributors | Sumner, David, Roberge, Martin, Maule, Charles P., Laguë, Claude, Crowe, Trever G. |
| Publisher | University of Saskatchewan |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://library.usask.ca/theses/available/etd-07282005-163454/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0015 seconds