The demand for higher quality steel and higher production rates in the production of steel slabs is ever increasing. These slabs are produced using a continuous casting process. The molten steel flow patterns inside the components of the caster play an important role in the quality of these products. A simple yet effective design method that yields optimum designs is required to design the systems influencing the flow patterns in the caster. The tundish is one of these systems. Traditionally, experimental methods were used in the design of these tundishes, making use of plant trials or water modelling. These methods are both costly and time consuming. More recently, Computational Fluid Dynamics (CFD) has established itself as a viable alternative to reduce the number of experimentation required, resulting in a reduction in the time scales and cost of the design process. Furthermore, CFD provides more insight into the flow process that is not available through experimentation only. The CFD process is usually based on a trial-and-error basis and relies heavily on the insight and experience of the designer to improve designs. Even an experienced designer will only be able to improve the design and does not necessarily guarantee optimum results. In this thesis, a more efficient design methodology is proposed. This methodology involves the combination of a mathematical optimiser with CFD to automate the design process. The methodology is tested on a four different industrial test cases. The first case involves the optimisation of a simple dam-weir configuration of a single strand caster. The position of the dam and weir relative to inlet region is optimised to reduce the dead volume and increase the inclusion removal. The second case involves the optimisation of a pouring box and baffle of a two-strand caster. In this case, the pouring box and baffle geometry is optimised to maximise the minimum residence time at operating level and a typical transition level. The third case deals with the geometry optimisation of an impact pad to reduce the surface turbulence that should result in a reduction in the particle entrainment from the slag layer. The last case continues from the third case where a dam position and height is optimised in conjunction with the optimised impact pad to maximise the inclusion removal on the slag layer. The cases studies show that a mathematical optimiser combined with CFD is a superior alternative compared to traditional design methods, in that it yields optimum designs for a tundish in a continuous casting system. / Thesis (PhD (Mechanical Engineering))--University of Pretoria, 2006. / Mechanical and Aeronautical Engineering / unrestricted
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/28496 |
| Date | 07 October 2005 |
| Creators | De Kock, Daniel Johannes |
| Contributors | Prof K J Craig, danie@up.ac.za |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
| Rights | © 2005, University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria. |
Page generated in 0.0012 seconds