Return to search

Synchronization in all-digital QAM receivers

The recent advance in Field Programmable Gate Array (FPGA) technology has been largely embraced by the communication industry, which views this technology as an effective and economical alternative to the design of Application Specific Integrated Circuits (ASICs). The primary reasons for switching to FPGAs are lower development and non-recurring engineering costs, the flexibility to design to a preliminary standard and adapt the design as the standard evolves, as well as the option of performing software updates in the field.<p>
A sector with strong interest in FPGAs is the coaxial cable TV/Internet distribution industry. The creation of soft preliminary standards by the standards organization governing the industry has been the main catalyst for the massive adoption of FPGAs by small to medium size companies, which see this technology as an opportunity to compete in this open market.<p>
Both the circuit speed and the economy of FPGA technology depend upon using algorithms that map efficiently into its fabric. Often it is prudent to sacrifice performance to improve either clock speed or economy when developing with FPGAs. The purpose of this research is to both revise and devise synchronization algorithms / structures for cable digital receivers that are to be implemented in FPGA. <p>
The main communication scheme used by the coaxial cable distribution industry is digital Quadrature Amplitude Modulation (QAM). The problem of synchronizing to the QAM signal in the receiver is not a new topic and several synchronization-related circuits, which were devised with ASICs implementation in mind, can be found in the open literature. Of interest in this thesis is the non-data-aided digital timing synchronizer that was proposed by D'Andrea to recover timing with no knowledge of the transmitted data. Accurate timing estimation was achieved by reshaping the received signal with a prefilter prior to estimating the timing. <p>
A problem with D'Andrea's synchronizer is that the prefilter for reshaping the signal is a relatively long Finite Impulse Response (FIR) filter, whose implementation requires a large number of multipliers. This may not have been an issue with ASICs in as much as the number of hardwired multipliers on a chip is not limited as it is in an FPGA chip. One contribution in this research is to propose an alternative to D'Andrea's synchronizer by replacing the long FIR filter with two single-pole Infinite Impulse Response (IIR) filters that are directly placed inside the timing recovery loop. This novel architecture, which drastically reduces the number of multipliers, is well suited for FPGA implementation.<p>
Non-data-aided feedforward synchronizers, which use the same prefilter as D'Andrea's synchronizer, have been receiving significant attention in recent years. Detailed performance analysis for these synchronizers can be found in the open literature. These synchronizers have the advantage of using a feedfordward structure rather than a feedback structure, as it is the case in D'Andrea's synchronizer, to estimate the timing. While D'Andrea's synchronizer has an advantage in performance over a non-data-aided feedforward synchronizer, this has not been reported in the literature. In this thesis a second contribution consists of thoroughly analyzing the steady state timing jitter in D'Andrea synchronizer by deriving a closed-form expression for the noise power spectrum and a simple equation to estimate the timing jitter variance. <p>
A third contribution is a novel low-complexity and fast acquisition coherent detector for the detection of Quadrature Phase Shift Keying (QPSK) (i.e., 4-QAM) symbols. This detector performs carrier phase synchronization much faster than a conventional coherent detector. The acquisition time is comparable to that of a differential detector. The fast acquisition comes at the expense of phase jitter, and the end result is a 1 dB performance loss over theoretical coherent detection. This detector can be used in place of the differential detector with no economic penalty. Doing so yields a performance advantage of about 2 dB over differential detection.

Identiferoai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:SSU.etd-04272009-155247
Date30 April 2009
CreatorsPelet, Eric R.
ContributorsKirlin, Lynn, Dinh, Anh van, Daku, Brian L., Bradley, Michael P., Bolton, Ronald J., Nguyen, Ha H., Salt, J. Eric
PublisherUniversity of Saskatchewan
Source SetsLibrary and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://library.usask.ca/theses/available/etd-04272009-155247/
Rightsunrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.0021 seconds