This research work proposes methods to rises the resistance and to evaluate the behavior of confined masonry walls built from clay solid bricks. These elements are widely used in Guerrero State (México) to build masonry structures, which should resist high lateral loads because of the serious seismic hazard. Therefore, a large experimental program to evaluate the mechanical properties of bricks and masonry currently required in the design process and masonry analysis was developed. To rises the masonry resistance and to counteract the influence of the compressive strength of the pieces on the masonry behavior, a high compressive strength mortar and a metallic reinforcement inside the joints were used. With respect to referenced values of the mechanical properties, some were similar and others were twice bigger. In this country zone, the first three tests under lateral load on full-scale confined masonry walls built from clay solid bricks were carried out in order to evaluate its behavior. A reinforcement composed by metallic hexagonal mesh-mortar coat was placed on the faces of two walls to rise or to restore the resistance. The walls showed good behavior and the reinforcement had adequate structural efficiency. Numerical models of panels and walls built by using the experimental data evaluated the envelope resistance, the failure mode and showed the influence of the mechanical properties of the pieces and joints on the global behavior. Two models had metallic reinforcement inside the joints. In addition, a constitutive law of the masonry defined from experimental results allowed to elaborate a simple model, which results were concordant with respect to the experimental results and similar to those calculated by complex models. Finally, two simplified models to evaluate the resistance of confined masonry walls by considering the failure plane on the wall diagonal were developed. One supposes the masonry failure by shear effect and the other supposes the masonry failure by induced tension. The ratio theoretical resistance vs. experimental resistance was adequate for walls built from different materials and tested under different loads, which had ratio Height/Length ranging from 0.74 to 1.26
| Identifer | oai:union.ndltd.org:CCSD/oai:tel.archives-ouvertes.fr:tel-00537380 |
| Date | 10 December 2009 |
| Creators | Sánchez Tizapa, Sulpicio |
| Publisher | Université Paris-Est |
| Source Sets | CCSD theses-EN-ligne, France |
| Language | English |
| Detected Language | English |
| Type | PhD thesis |
Page generated in 0.0034 seconds