Return to search

Exploiting the Thermoresponsive Properties of Poly(2-oxazoline)s for Biofabrication / Anwendung der Thermoresponsivität von Poly(2-oxazolin) für die Biofabrikation

In this thesis, non-modified POx, namely PnPrOx and PcycloPrOx, with an LCST in the physiological range between 20 and 37°C have been utilized as materials for three different biofabrication approaches. Their thermoresponsive behavior and processability were exploited to establish an easy-to-apply coating for cell sheet engineering, a novel method to create biomimetic scaffolds based on aligned fibrils via Melt Electrowriting (MEW) and the application of melt electrowritten sacrificial scaffolds for microchannel creation for hydrogels.
Chapter 3 describes the establishment of a thermoresponsive coating for tissue culture plates. Here, PnPrOx was simply dissolved in water and dried in well plates and petri dishes in an oven. PnPrOx adsorbed to the surface, and the addition of warm media generated a cell culture compatible coating. It was shown that different cell types were able to attach and proliferate. After confluency, temperature reduction led to the detachment of cell sheets. Compared to standard procedures for surface coating, the thermoresponsive polymer is not bound covalently to the surface and therefore does not require specialized equipment and chemical knowledge. However, it should be noted that the detachment of the cell layer requires the dissolution of the PnPrOx-coating, leading to possible polymer contamination. Although it is only a small amount of polymer dissolved in the media, the detached cell sheets need to be washed by media exchange for further processing if required. ... / In dieser Dissertation wurden die unmodifizierten Poly(2-oxazoline) PnPrOx und PcycloProx, welche eine LCST im physiologischen Bereich zwischen 20 und 37°C aufweisen, für drei verschiedene Biofabrikationsansätze verwendet. Deren Thermoresponsivität und Prozessierbarkeit wurde genutzt, um ein simples Beschichten von Oberflächen für Cell Sheet Engineering, eine neue Methode zur Herstellung biomimetischer Gerüststrukturen basierend auf der Generierung von Fibrillenbündeln via Melt Electrowriting und die Anwendung als Opferstrukturen zur Generierung von Mikrokanälen in Hydrogelen zu etablieren.

Identiferoai:union.ndltd.org:uni-wuerzburg.de/oai:opus.bibliothek.uni-wuerzburg.de:24746
Date January 2022
CreatorsRyma, Matthias
Source SetsUniversity of Würzburg
LanguageEnglish
Detected LanguageEnglish
Typedoctoralthesis, doc-type:doctoralThesis
Formatapplication/pdf
Rightshttps://opus.bibliothek.uni-wuerzburg.de/doku/lic_mit_pod.php, info:eu-repo/semantics/openAccess

Page generated in 0.0021 seconds