Increasing tool life is a significant objective in production. Achieving this objective in a machining process poses a significant challenge, especially during cutting hard-to-cut materials such as superalloys, due to the severe tool chipping/failure at the beginning of the cut. Although numerous attempts have been carried out to improve tool performance and prolong tool life during the machining of difficult-to-cut materials over the past several years, researchers have not obtained sufficient control over sudden tool failure/chipping. The focus of this study is to prolong tool life and control tool chipping by developing an ultra-soft deposited layer on the cutting tool that can protect it during the machining of difficult-to-cut materials such as Inconel 718. In the current study, an ultra-soft layer of material is deposited on the tool through two different techniques; a typical physical vapor deposition (PVD) technique and a novel developed method called “pre-machining”. In the PVD method, the soft layer is deposited under a high vacuum environment using a PVD coater. In the novel pre-machining method, the soft layer is deposited through a very short machining process involving Al-Si. It should be mentioned that soft coatings have never been used before for machining applications of difficult-to-cut materials including Inconel 718.
This study shows that in contrast to what is expected, depositing an ultra-soft layer on the cutting tool significantly improves tool performance, by reducing chipping, and improving the machined surface integrity during cutting of Inconel 718. The obtained results show up to a 500% ± 10% improvement in tool life and around a 150% ± 10% reduction in cutting forces. Significant reductions in work hardening, residual stress, and surface roughness on the machined surface were other main achievements of the current study. / Thesis / Doctor of Philosophy (PhD) / Inconel 718 is considered to be a difficult-to-cut material due to its poor machinability. Significant tool failure at the early stage of cutting is the main challenge of machining this material and is the most significant contributing factor to its high manufacturing costs. Studies show that the common methods used to tackle this issue have not been completely successful. The goal of the present study is to tackle the machining challenges of Inconel 718 by developing tool coatings that meet the specific needs of the material to eliminate tool failure and thereby improve overall machining performance. For this purpose, a new tool coating material and a novel deposition technique that can be used as an alternative for commonly used coatings were developed in this study to improve the tool performance during the machining of Inconel 718. In addition, thorough studies have been carried out to gain a better understanding of the dominant wear phenomena and tool surface treatments that result in an improvement in the machinability of Inconel 718.
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/27444 |
| Date | 17 December 2020 |
| Creators | Montazeri, Saharnaz |
| Contributors | Veldhuis, Stephen. C, Mechanical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0024 seconds