Return to search

Anisotropy Evolution Due to Surface Treatment on 3D-Printed Fused Deposition Modeling (FDM) of Acrylonitrile Butadiene Styrene (ABS)

Purpose: This paper will present insight to the methodology and results of the experimental characterization of Acrylonitrile Butadiene Styrene (ABS) using Fused Deposition Modeling (FDM). The work in this research explored the effects of print orientation, surface treatment, and ultraviolet (UV) light degradation with the utilization of Digital Image Correlation (DIC) on ABS tensile specimens.
Design/methodology: ABS specimens were printed at three build orientations (flat (0 degrees), 45 degrees, and up-right (90 degrees)). Each of these specimens were treated with three different surface treatments including a control (acrylic paint, Cyanoacrylate, and Diglycidyl Bisphenol A) followed by exposure to UV light to the respective batches. This experiment design will provide tensile direction properties with the effect of thermoset coatings and UV degradation. Dogbone FDM specimens based on ASTM standard D638 type IV were printed on a Stratasys Dimension SST (Soluble Support Technology) 1200es 3D Printer and loaded into a MTS Landmark Servohydraulic Test Systems. Analysis was preformed on the fracture section of the tensile specimens utilized DIC and comparing Ultimate Tensile Strength (UTS) and Ultimate Fracture Strength (UFS).
Findings: From the results UV light did not play a large factor in the strength of the specimens. The print orientation showed the largest anisotropic behavior where some specimens experienced as much as a 54% difference in ultimate tensile strength. Thermoset coated specimens experienced a maximum of 2% increase in strength for the Cyanoacrylate and Diglycidyl Bisphenol A specimens where the acrylic paint and natural did not. Several findings were of value when looking at the stress strain plots.
Originality/value: This paper provides knowledge to the limited work on print build orientation, thermoset coatings and, UV light on ABS specimens. Very little to no work has been done on these three properties. This paper can serve as the foundation of future work on external applications on ABS plastics.

Identiferoai:union.ndltd.org:ucf.edu/oai:stars.library.ucf.edu:honorstheses-1277
Date01 January 2017
CreatorsLozinski, Blake E
PublisherSTARS
Source SetsUniversity of Central Florida
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceHonors Undergraduate Theses

Page generated in 0.0026 seconds