Estrogens, alkylphenols and bisphenol-A, enter the environment through waste water systems and waste disposal of manufactured products e.g. detergents, paints, polycarbonates and flameretardants. These analytes disrupt the endocrine function of living organisms affecting their reproductive health and those of future generations. Gas phase low molecular- mass aldehydes and amines are typically eye, nose, and throat irritants. Formaldehyde is classified as a probable human carcinogen. Given their negative impact on human health it is urgent to monitor pollutants at extremely low levels in both air and water. The aqueous pollutants are often concentrated using solid phase extraction cartridges or liquid-liquid extraction followed by derivatization. Methods that can most effectively and selectively pre-concentrate aldehydes and amines involve in situ derivatization. Unfortunately, the derivatizing reagents as well as their associated solvents or adsorbents, are responsible for problems encountered with these methods. Polydimethylsiloxane (PDMS) has emerged as the ideal concentration and reaction medium for trace analysis. However the expensive commercial devices such as SPME and SBSE both require the samples to be returned to the laboratory for concentration. Due to the open tubular nature of the PDMS multichannel trap (MCT), developed in our laboratory, it is ideally suited for on-site and online sampling. The MCTs have a high analyte capacity owing to the large volume of PDMS available for concentration. The derivatization reaction can be performed in situ providing a “onepot concentration and reaction device”. This allows for reduced risk of contamination of / or losses of the sample and a sampling method that can cater for both air and water samples. To demonstrate the versatility of the PDMS MCT, two approaches for concentration in PDMS were investigated in this study, namely, 1) the on-line concentration and in situ derivatization of volatile polar analytes from air followed by REMPI-TOFMS detection, and 2) the concentration of phenolic lipophilic analytes from water requiring derivatization prior to analysis by GC/MS. 1) Analyte and derivatizing reagent were simultaneously introduced into the PDMS trap using a ypress- fit connector. The reaction occurs in situ followed by thermal desorption using a thermal modulator array alone or in conjunction with a thermal desorption unit. The aldehydes and amine derivatives were successfully detected by the REMPI-TOFMS. Reaction efficiencies were determined at room temperature without catalysts. Formaldehyde yielded a low reaction/concentration efficiency of 41 % with phenylhydrazine in PDMS, while acetaldehyde, acrolein and crotonal displayed much improved values of 92, 61 and 74 % respectively. Both propylamine and butylamine yielded 28 % reaction/concentration efficiency with benzaldehyde in the PDMS matrix. Detection limits obtained with this technique were significantly lower than the permissible exposure limits set by the Occupational Safety and Health Administration. It should be noted that the detection limits were not determined by actual measurement but by extrapolation from a larger signal. 2) Aqueous analytes were concentrated in the PDMS MCT using a gravity flow rate of ~50 ìl/min. The trap was dried and 5 ìl derivatizing reagent added. At room temperature and without the presence of a catalyst, the reaction of alkylphenols with trifluoroacetic acid anhydride in the PDMS matrix was 100% complete after 5 minutes. Bisphenol-A reacted less than 50 % to completion during this period, but the amount of derivative formed remained constant. This study revealed that extraction efficiencies of the alkylphenols and bisphenol-A off the PDMS trap have poor batch-tobatch repeatability indicating that the PDMS matrix was not homogenous. For two different PDMS batches: tert-octylphenol displayed an extraction efficiency of 70 and 79%, nonylphenol displayed 84 and 43% while Bisphenol-A displayed 10 and 26% respectively. The thermally desorbed derivatives were analysed by GC/MS. Despite background contamination in the desorption unit, detection limits were at the ppt level. Detection limits were not determined by actual measurement but by extrapolation from a larger signal. / Thesis (PhD)--University of Pretoria, 2009. / Chemistry / unrestricted
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/27149 |
| Date | 06 January 2009 |
| Creators | Fernandes-Whaley, Maria Jose |
| Contributors | Prof E Rohwer, mfwhaley@nmisa.org |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
| Rights | © University of Pretoria 2008 D539/ |
Page generated in 0.0032 seconds