The profound digitization of modern microelectronic modules made Analog-to-
Digital converters (ADC) key components in many systems. With resolutions up to
14bits and sampling rates in the 100s of MHz, the pipeline ADC is a prime candidate for
a wide range of applications such as instrumentation, communications and consumer
electronics. However, while past work focused on enhancing the performance of the
pipeline ADC from an architectural standpoint, little has been done to individually
address its fundamental building blocks. This work aims to achieve the latter by
proposing design techniques to improve the performance of these blocks with minimal
power consumption in low voltage environments, such that collectively high
performance is achieved in the pipeline ADC.
Towards this goal, a Recycling Folded Cascode (RFC) amplifier is proposed as
an enhancement to the general performance of the conventional folded cascode. Tested
in Taiwan Semiconductor Manufacturing Company (TSMC) 0.18?m Complementary
Metal Oxide Semiconductor (CMOS) technology, the RFC provides twice the
bandwidth, 8-10dB additional gain, more than twice the slew rate and improved noise performance over the conventional folded cascode-all at no additional power or silicon
area. The direct auto-zeroing offset cancellation scheme is optimized for low voltage
environments using a dual level common mode feedback (CMFB) circuit, and amplifier
differential offsets up to 50mV are effectively cancelled. Together with the RFC, the
dual level CMFB was used to implement a sample and hold amplifier driving a singleended
load of 1.4pF and using only 2.6mA; at 200MS/s better than 9bit linearity is
achieved. Finally a power conscious technique is proposed to reduce the kickback noise
of dynamic comparators without resorting to the use of pre-amplifiers. When all
techniques are collectively used to implement a 1Vpp 10bit 160MS/s pipeline ADC in
Semiconductor Manufacturing International Corporation (SMIC) 0.18[mu]m CMOS, 9.2
effective number of bits (ENOB) is achieved with a near Nyquist-rate full scale signal.
The ADC uses an area of 1.1mm2 and consumes 42mW in its analog core. Compared to
recent state-of-the-art implementations in the 100-200MS/s range, the presented pipeline
ADC uses the least power per conversion rated at 0.45pJ/conversion-step.
| Identifer | oai:union.ndltd.org:tamu.edu/oai:repository.tamu.edu:1969.1/ETD-TAMU-2009-12-7541 |
| Date | 2009 December 1900 |
| Creators | Assaad, Rida Shawky |
| Contributors | Silva-Martinez, Jose |
| Source Sets | Texas A and M University |
| Language | en_US |
| Detected Language | English |
| Type | Book, Thesis, Electronic Dissertation, text |
| Format | application/pdf |
Page generated in 0.002 seconds