Return to search

ARGON-OXYGEN DECARBURIZATION OF HIGH MANGANESE STEELS

Manganese is an essential alloying element in the 2nd and 3rd generation of Advanced High Strength steels (AHSS) containing 5 to 25% manganese. A combination of excellent strength and ductility makes these grades of steel attractive for the automotive industry. To produce these steels to meet metallurgical requirements the main concern for the steelmakers is to decrease the carbon concentration as low as 0.1% while suppressing the excessive manganese losses at high temperatures. Argon Oxygen Decarburization (AOD) is a promising candidate for the refining of high manganese steels.
This work has studied the kinetics of decarburization and manganese losses during the argon oxygen bubbling into a wide range of iron-manganese-carbon alloys. It was shown that decreasing the initial carbon content increased the manganese loss. In the competition between manganese and carbon for oxygen, alloys with lower initial manganese concentrations consumed a higher portion of oxygen for decarburization. This behavior was not expected by thermodynamics and the results did not support the concept of the critical carbon content either. It was demonstrated that for lower range carbon (≤0.42%) alloys, the total manganese loss can be explained by considering multiple mechanisms in parallel; oxide formation (MnO) and vapor formation (Mn (g)), and formation of Manganese mist by evaporation-condensation (Mn (l)). The evaporation-condensation mechanism was proposed with the assumption that the heat generated from MnO and CO formation increases the temperature at the surface of the bubble which facilitates the evaporation of manganese at a high vapor pressure. Consequently, manganese vapor condenses as fine droplets at the lower temperature inside the bubble.
Although dilution of oxygen with argon increased the efficiency of oxygen for decarburization as expected from the mechanism of the AOD process, manganese loss did not stop completely at higher argon concentrations in the gas mixture. Therefore, the bubble and melt do not fully equilibrate with respect to Mn and C.
For high carbon alloys (1%), there was excess oxygen after accounting for CO and MnO formation. According to mass balance and thermodynamic calculations, and assuming manganese loss by evaporation was negligible it was shown that oxygen was distributed amongst MnO, FeO, CO, and CO2.
It was demonstrated that increasing temperature resulted in the higher manganese loss as a mist and by simple evaporation due to the increased vapor pressure and less manganese loss by oxidation. Furthermore, it was found that the rate of decarburization increased with increasing temperature due to more partitioning of oxygen to carbon than manganese.
In addition, it was found that the variations of depth of lance submergence did not affect the rate of decarburization or manganese loss. This means that the reactions occur within such a short time that prolonged time after the reaction is completed does not lead to a repartitioning of the species. / Thesis / Doctor of Philosophy (PhD)

Identiferoai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/26303
Date18 February 2021
CreatorsRafiei, Aliyeh
ContributorsColey, Kenneth S., Irons, Gordon A., Materials Science and Engineering
Source SetsMcMaster University
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.002 seconds