Silver is a precious metal having antibacterial property and widely used in industry mostly for water purification and medicinal products. Therefore, the determination of trace levels of silver is important for industrial applications. Flame atomic absorption spectrometry (FAAS) is a popular technique for the determination of relatively low concentration levels. This mature technique owes its widespread application to its simplicity and low cost. However, for some occasions, FAAS technique suffers from its low sensitivity because of low nebulization efficiency and relatively short residence time of analyte atoms in the measurement zone. In order to overcome this sensitivity problem, atom traps have been developed in recent years. Slotted quartz tube (SQT) is an accessory designed to use as an atom trap in conventional flame atomic absorption burner head. This thesis study involves the development of a sensitive, simple and economical technique with the help of the SQT for the determination silver. Firstly, the technique known as SQT-FAAS was used to increase the residence time of analyte atoms in the measurement zone. In this case, limit of detection (LOD) and characteristic concentration (C0) values were found to be 19 ng/mL and 35 ng/mL, respectively. Enhancement in sensitivity with respect to FAAS was found to be 2.31 fold using SQT-FAAS. Regarding the angle between the two slots of the SQT, 180° / configuration was used. Secondly, in order to improve sensitivity further, the SQT was used as an atom trap (AT) where the analyte is accumulated in its inner wall prior to re-atomization. The signal is formed after reatomization
of analyte atoms on the trap surface by introduction of organic solvent. For this purpose, uncoated SQT was used as a trap medium. However, there was a memory effect. Therefore, the SQT inner surface was coated with different coating elements and theoptimum conditions were found by using W-coated SQT-AT-FAAS technique. In the presence of a lean air-acetylene flame, analyte atoms were trapped in the inner surface of the SQT for 5.0 min and then revolatilized with the
introduction of 25 &mu / L isobutyl methyl ketone (IBMK) / afterwards, a transient signal was obtained. These optimized parameters were used for uncoated SQT, W-coated SQT and Zr-coated SQT atom trap techniques. Sample suction rate was 6.25 mL/min in all techniques. Sensitivity was increased 54 fold using uncoated SQT-AT-FAAS technique with respect to simple FAAS technique. When W-coated SQT-AT-FAAS technique was applied, 135 fold sensitivity enhancement was obtained with respect to FAAS technique. The best sensitivity enhancement, 270 fold, was obtained using Zr-coated SQT-AT-FAAS technique. In addition, the Ag signals were more reproducible (%RSD, 1.21) when Zr was used as a coating element. After the
sensitive technique was developed, interference effects of some transition and noble metals and hydride forming elements on Ag signals were investigated. Finally, surface studies were done to determine the chemical state of Ag during trapping
period by using X-ray Photoelectron Spectroscopy (XPS). It was observed that the Ag analyte is retained on the SQT surface in its oxide form.
Identifer | oai:union.ndltd.org:METU/oai:etd.lib.metu.edu.tr:http://etd.lib.metu.edu.tr/upload/12613695/index.pdf |
Date | 01 September 2011 |
Creators | Karaman, Gamze |
Contributors | Ataman, O. Yavuz |
Publisher | METU |
Source Sets | Middle East Technical Univ. |
Language | English |
Detected Language | English |
Type | M.S. Thesis |
Format | text/pdf |
Rights | To liberate the content for public access |
Page generated in 0.0018 seconds