Return to search

Optimization of Moving Bed Biofilm Reactor (MBBR) Operation for Brewery Wastewater Treatment

The significant rise in the number of micro-breweries in North America has increased the need for efficient on-site industrial wastewater facilities. Brewery wastewater is considered to be a high strength food industry wastewater with high variability in terms of both organic and hydraulic loading. Small breweries require cost-effective, reliable, and simple to operate treatment technologies to properly manage their brewery wastewaters. Moving bed biofilm reactor (MBBR) technology has shown promise at the lab-scale and full-scale with respect to brewery effluent treatment. MBBR systems have the capability for short hydraulic retention times (HRT), high organic loading rates, as well as increased treatment capacity and stability due to biofilm retention, all within a compact reactor size when compared to other aerobic and attached growth treatment options.
Two MBBR systems utilizing two different carrier types (Kaldnes K5 and Kontakt), and a suspended growth (SG) control reactor, were used in this study to investigate the impacts of surface area loading rate (SALR) and HRT on attached growth (AG) and SG kinetics and carrier type for brewery wastewater at 2000 mg-sCOD/L. An increase in SALR from 10-55 g-sCOD/m2/d while at an HRT of 12 hr resulted in no significant impact in total volumetric removal rates between the MBBR systems and the SG control reactor; however, MLSS concentrations were lower for the MBBR systems at SALRs below 55 g-sCOD/m2/d, which indicated AG contribution. Over 92% soluble chemical oxygen demand (sCOD) removal was achieved at each SALR in each of the three reactors. These results indicated that the reactors were substrate limited and SG controlled. Due to the SG dependency, the difference between the two types of carriers was indeterminate. A decrease in HRT from 12-3 hr while maintaining an SALR of 40 g-sCOD/m2/d resulted in a shift from SG to AG dependency in the MBBR systems. The total volumetric removal rates for the MBBR systems were significantly higher at HRTs of 3 and 4 hr as compared to the SG control reactor. The AG volumetric removal rates from both MBBR systems were highest at an HRT of 3 and 4 hr. At an HRT of 12 hr all three reactors maintained over 92% sCOD removal; however, at an HRT of 4 hr the SG control reactor dropped to 88% and at 3 hr to 61%, whereas the MBBR systems maintained 95% removal at an HRT of 4 hr and only decreased to 73% at 3 hr. These results indicated that the MBBR systems were more effective at lower HRT than the SG control reactor, with no significant difference observed between the two carrier types tested.
Biofilm morphology and viability from each of the two carriers utilized in the study of moving bed biofilm reactor (MBBR) treatment of brewery wastewater were investigated using stereoscopy and confocal laser scanning microscopy (CLSM) in combination with live/dead cell staining. Both carriers demonstrated thicker and more viable biofilms at high SALR and denser and less viable biofilms at low SALR. At lower HRT, the carriers reacted differently resulting in thicker, but less dense biofilms on the Kontakt carriers and thinner, but more dense biofilms on the K5 carriers. However, no trend in cell viability was observed with change in HRT. Although the systems were suspended growth (SG) dominated, based on the MBBR kinetics and carrier biofilm morphology and cell viability, either carrier would be a viable choice for an MBBR treating brewery wastewater at HRTs between 4 to 12 hr and SALRs between 10-55 g-sCOD/m2/d.

Identiferoai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/39147
Date06 May 2019
CreatorsBoyle, Kellie
ContributorsKinsley, Christopher
PublisherUniversité d'Ottawa / University of Ottawa
Source SetsUniversité d’Ottawa
LanguageEnglish
Detected LanguageEnglish
TypeThesis
Formatapplication/pdf

Page generated in 0.0019 seconds