In low power, battery-operated, portable applications, like cell phones, PDAs, digital cameras, etc., miniaturization at a low cost is a prominent driving factor behind product development and marketing efforts. As such, power supplies in portable applications must not only conform and adapt to their highly integrated on-chip and in-package environments but also, more intrinsically, respond quickly to fast load dumps to achieve and maintain high accuracy. The frequency-compensation network, however, limits speed and regulation performance because, in catering to all combinations of the output capacitor, its equivalent series resistance Resr, and the power inductor resulting from tolerance and modal design targets, it must compensate the worst-case condition and therefore restrain the performance of all other possible scenarios. Sigma-delta control, which addresses this issue in buck converters by easing its compensation requirements and offering one-cycle transient response, has not been able to simultaneously achieve high bandwidth, high accuracy, and wide LC-Resr compliance in boost (step-up) converters. This thesis investigates and presents techniques to achieve sigma-delta control in boost converters by essentially using explicit current and voltage control loops. The proposed techniques are developed conceptually and analytical expressions for stability range and transient response are derived. The proposed concepts are validated and quantified through PCB and IC prototypes to yield 1.41 to 6 times faster transient response than the state of the art in current-mode boost supplies, and this without any compromise in LC-Resr compliance range.
| Identifer | oai:union.ndltd.org:GATECH/oai:smartech.gatech.edu:1853/22530 |
| Date | 26 March 2008 |
| Creators | Keskar, Neeraj |
| Publisher | Georgia Institute of Technology |
| Source Sets | Georgia Tech Electronic Thesis and Dissertation Archive |
| Detected Language | English |
| Type | Dissertation |
Page generated in 0.0015 seconds