Return to search

Microstructure Evolution in 304L Stainless Steel Subjected to Hot Torsion at Elevated Temperature

The current study focus on investigating a relationship between processing variables and microstructure evolution mechanism in 304L stainless steel subjected to hot torsion. The Gleeble 3800 with Mobile Torsion Unit (MTU) is utilized in the current study to conduct hot torsion test of 304L stainless steel. Samples are rotated at 1100℃ in the shear strain rate range of 0.02s-1 to 4.70s-1 and the shear strain range of 0.5 to 4. Orientation imaging microscopy (OIM) technique is used to collect and analyze the microstructure. At low strains (≤1) and strain rate (0.02s-1), average grain size remains relatively constant, but the lengths of DSs and LABs increase within grains. These are characteristics of the dynamic recovery (DRV). With increasing strain and strain rate, the lengths of DSs, LABs and HABs increase, accompanied by the decrease of average grain size. Subgrains with HAB segments are observed. These are characteristics of continuous dynamic recrystallization (CDRX). At strain rates greater than or equal to 0.94s-1, the fraction of deformation texture is about 3 times higher than that of rotated cube texture. The average grain size increases relative to that at a strain rate of 0.20s-1, accompanied by the increase of twin length per area. This indicates that grain growth take place after CDRX. Sigma phase is not observed in the current study due to the lack of static recrystallization (SRX) and the higher cooling rate.

Identiferoai:union.ndltd.org:BGMYU2/oai:scholarsarchive.byu.edu:etd-3853
Date19 September 2011
CreatorsLu, Jian
PublisherBYU ScholarsArchive
Source SetsBrigham Young University
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceTheses and Dissertations
Rightshttp://lib.byu.edu/about/copyright/

Page generated in 0.002 seconds