Return to search

Investigation of deposition parameters in ultrasonic spray pyrolysis for fabrication of solid oxide fuel cell cathode

Solid oxide fuel cell (SOFC) research is currently underway to improve performance, cost and durability by lowering the operating temperature to ~600°C. One approach is to design fabrication processes capable of tailoring desirable cathode microstructures to enhance mass and charge transfer properties through the porous medium. The aim of this study is to develop a cost effective fabrication technique for deposition of novel microstructures, specifically, functionally graded thin films of LSM oxide with porosity graded structure for use as IT- SOFCs cathode. Spray pyrolysis method was chosen as a low-temperature processing technique for deposition of porous LSM films onto dense YSZ substrates. The effort was directed toward the optimization of the processing conditions for deposition of high quality LSM films with variety of morphologies in the range of dense to porous microstructures. Results of optimization studies on spray parameters revealed that the substrate surface temperature is the most critical parameter influencing the roughness and morphology, porosity, cracking and crystallinity of the film. Physical and chemical properties of deposited thin films such as porosity, morphology, phase crystallinity and compositional homogeneity have shown to be extensively dependent on the deposition temperature as well as solution flow rate and the type of precursor solution among other parameters. The LSM film prepared from organo-metallic precursor and organic solvent showed a homogeneous crack-free microstructure before and after heat treatment as opposed to aqueous solution. Also, increasing the deposition temperature and the solution flow rate, in the specific range of 520-580 ℃
and 0.73-1.58 ml/min, respectively, leads to change the microstructure from a dense to a highly porous film. Taking the advantage of simplicity of spray pyrolysis technique combined with using metal-organic compounds, the conventional ultrasonic spray system was modified to a novel system whereby highly crystalline multi-layered porosity graded LSM cathode with columnar morphology and good electrical conductivity in the range of 500-700 °C was fabricated through a multi-step spray and via applying optimum combination of spray parameters. This achievement for the current graded LSM cathode would allow its use in IT-SOFCs.

Identiferoai:union.ndltd.org:GATECH/oai:smartech.gatech.edu:1853/26670
Date19 November 2008
CreatorsAmani Hamedani, Hoda
PublisherGeorgia Institute of Technology
Source SetsGeorgia Tech Electronic Thesis and Dissertation Archive
Detected LanguageEnglish
TypeThesis

Page generated in 0.0019 seconds