Submitted in fulfillment of the requirements for the degree of Master in Engineering: Mechanical Engineering, Durban University of Technology, Durban, South Africa, 2017. / Despite the huge improvements made in the development of vehicle brake pad materials, problems such long stopping distances, noise pollution, and heat dissipation still continue to persist. In this regard, a novel polymer-based hybrid nanocomposite brake pad (HC) has been developed. Here, a combination of carbon-based materials, including those at a nanoscale, was used to produce the brake pad. The coefficient of friction, wear rate, noise level, and interfacial temperature was investigated and compared with that of a commercial brake pad material (CR). It was found that the brake pad performance varied with the formulation of each pad. Hybrid nanocomposite brake pads material exhibited superior performance in most tests when compared to the commercial brake pad. They exhibited a 65% lower wear rate, 55% lower noise level, 90% shorter stopping distance, and 71 % lower interfacial temperature than the commercial brake pad (CR).
Furthermore, mechanical properties such as hardness, compressive strength, shear strength, and impact resistance were also evaluated. The material exhibited a 376% higher shear strength, 100% improved compressive strength, 77% greater modulus and 100% higher impact strength than the commercial brake pad. The hardness of both brake pads material was statistically comparable. Additionally, the thermal stability, degradation, water and oil absorption behaviour were measured. It was found that HC brake pad material exhibited a 100% lower water absorption and 80% oil absorption rate. The brake pads also exhibited a thermal stability within the brake pad standard maximum working temperature of 300 -400 0C.
The superior performance of hybrid nanocomposite brake pad material observed was due to synergism between the carbon-carbon additives and uniform dispersion of carbon fiber as shown in Figure 4.16. Scanning electron microscopy study was subsequently performed on fracture and worn surfaces of the brake pads. The micrographs show changes in the structural formation after the incorporation of carbon based fillers. It also shows the smooth structure and uniform dispersion of the carbon fiber. The smooth surface of the worn brake pad is an indicative of a harder structure. No ploughing or score marks were evident. Hence, it was deduced that the reinforced had superior mechanical and tribological properties. These improved properties are suggestive of materials that may be successfully used for brake pad application. / M
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:dut/oai:ir.dut.ac.za:10321/2666 |
| Date | January 2017 |
| Creators | Gbadeyan, Oluwatoyin Joseph |
| Contributors | Kanny, Krishnan, Mohan, T.P. |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | 104 p |
Page generated in 0.0019 seconds