The constantly tightening emission regulations demand the engines to be moreefficient, to get more power out of smaller engines. Higher engine loads andcomponent temperatures are causing more stresses to engine components. Therefore,a company that produces engines wanted to study if it would be possible to increasethe capabilities of the components by optimising the used material. In this final project work, a cylinder head will be studied. The cylinder heads for theengines are made of ductile cast iron. The limits of that material are near safety limits,and therefore a better material is needed. In this work are some previous studiesanalysed and tried to find how to optimise the used material. The optimised materialshould have better thermal conductivity properties combined with sufficient strengthproperties. Previous studies were analysed to gather knowledge of the elements that affect thematerial parameters. Those studies showed that copper, silicon, pearlite fraction, andthe use of chills are the elements to be optimised. Silicon and pearlite fraction waschosen as optimisation parameters because of their effect on the thermal conductivityand strength properties. Copper was chosen as an optimisation variable due to its effecton the pearlite formation. Chills were used to affect the cooling rate and thereby thepearlite formation. The work was made using MAGMASOFT™ simulation software to simulate cylinderhead casting. The simulated cylinder head was divided into 4 parts for the simulations.For those sections were then set targets for pearlite fraction according to previousstudies. The silicon content was kept constant in the simulation, based on the studiespresented in this work. Copper content was simulated with variations from 0 to 0.7weight-%, and chill heights were simulated from 20 to 60 mm and without chills. After simulating the different variables, the results were analysed. Then the selectedcasting simulation result was mapped to finite element simulation mesh to include thelocal material parameters to finite element simulation. With the finite elementsimulation, the estimated lifetime of the component was simulated. By analysing the casting simulation results, an optimal combination was found. Theoptimal material parameters for a cylinder head casting would be copper 0.5weight-%, silicon 1.9 weight-% and chills thicker than 40 mm on the flame plate. Theoptimised material gives more possibilities to develop engines even further when thecomponent demands are growing.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:hj-54500 |
| Date | January 2021 |
| Creators | Mäkinen, Katri |
| Publisher | Jönköping University, JTH, Material och tillverkning |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, info:eu-repo/semantics/bachelorThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
Page generated in 0.0025 seconds