Return to search

Characterization of Expansive Soil For Retaining Wall Design

The current design procedure for cantilever structures on spread footings in the Texas Department of Transportation (TxDOT) is based on horizontal pressure that is calculated by using Rankine's and Coulomb's theory. These are classical Geotechnical Engineering methods. Horizontal earth pressure due to moisture and volume change in high plasticity soil is not determined by these classical methods. However, horizontal pressure on most of the cantilever retaining structures in Texas is determined by following the classical methods. In recent years, a number of consultants have considered the horizontal pressure due to swelling on cantilever retaining structures in Texas. However, the proposed horizontal pressure by consultants is 10-20 times higher than the classical horizontal pressure. This method of cantilever retaining structure design without knowing the real pressure and stress pattern increases the thickness of the wall, and raises the cost of construction.

This study focuses on providing adequate patterns of lateral earth pressure distribution on cantilever retaining structures in expansive soil. These retaining wall structures are subject to swelling pressures which cause horizontal pressures that are larger than the classical especially near the ground surface.

Beside the prediction of lateral earth pressure distribution, the relations between water content, volume change and suction change are determined. Based on the laboratory testing program conducted, Soil Water Characteristic Curves (SWCC) are determined for a site located at the intersection of I-35 and Walters Street in San Antonio, Texas. Additionally, relations between volume change with confining pressure curve, water content change with the change of confining pressure curve, water content change with change of matric suction and volume change with change of matric suction curves are generated based on laboratory tests.

There are a number of available mass volume measurement methods that use mostly mercury or paraffin to obtain volume measurements. Although these methods are reported in the literature, they are not used in practice due to application limitations like safety, time, and cost. In order to overcome these limitations, a new method was developed to measure the volume of soil mass by using sand displacement. This new method is an inexpensive, safe, and simple way to measure mass volume by Ottawa sand.

Identiferoai:union.ndltd.org:tamu.edu/oai:repository.tamu.edu:1969.1/ETD-TAMU-2011-12-10505
Date2011 December 1900
CreatorsSahin, Hakan
ContributorsLytton, Robert L., Aubeny, Charles P., Biscontin, Giovanna, Karaman, Ibrahim
Source SetsTexas A and M University
Languageen_US
Detected LanguageEnglish
TypeThesis, thesis, text
Formatapplication/pdf

Page generated in 0.0022 seconds