Return to search

An Experimental Investigation of the STOL Performance of Cal Poly's AMELIA in the NFAC

Results from Cal Poly's recent wind tunnel test, during the Winter of 2011-2012, in the 40- by 80-foot test section at the National Full-Scale Aerodynamics Complex (NFAC) at NASA Ames Research Center are presented. AMELIA, the Advanced Model for Extreme Lift and Improved Aeroacoustics, is the first full-span, cruise efficient, short take-off and landing (CESTOL) model incorporating leading- and trailing-edge blowing wing circulation control and over-the-wing mounted turbine propulsion simulators (TPS) to date. Testing of the 10 foot span model proved successful and was the result of a 5 year NASA Fundamental Aeronautics Program Research Announcement. The test generated extensive low-speed experimental aerodynamic and acoustic measurements. All of the results associated with Cal Poly's effort will be available in an open-source validation database with the goal of advancing the state-of-the-art in prediction capabilities for modeling aircraft with next generation technologies, focusing on NASA's N+2 generation goals.
The model's modular design allowed for testing of 4 major configurations. Results from all configurations are presented. Out of a total of 292 data runs, 14 repeat run configurations were obtained. Overall repeatability of test data are good. Factors contributing to non-repeatability in the test data were assessed and showed high pressure air line temperature to be a primary factor. Test data shows drastic improvements in performance are obtained when incorporating leading edge blowing: wing stall can be delayed to more than 25 degrees angle-of-attack at lift coefficients exceeding six. Without the introduction of leading edge blowing to increase boundary layer momentum and maintain flow attachment around the leading edge, STOL performance suffers. Similar runs for isolated trailing edge blowing show a reduction in maximum lift coefficient to three with stall occurring at zero angle-of-attack. Testing at two engine pylon heights allowed for the highly coupled propulsion and flow control system to be characterized.

Identiferoai:union.ndltd.org:CALPOLY/oai:digitalcommons.calpoly.edu:theses-1979
Date01 April 2013
CreatorsLichtwardt, Jonathan Andrew
PublisherDigitalCommons@CalPoly
Source SetsCalifornia Polytechnic State University
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceMaster's Theses and Project Reports

Page generated in 0.0018 seconds