An investigation of IsoTruss structures in bending and torsion was conducted. A model was developed in ANSYS APDL where bay length and longitudinal member to helical member cross-sectional area ratio could be varied while holding the diameter constant. The model was validated using previously reported values from analytical models and empirical data. The model was used to make predictions of a specific geometry that was manufactured, tested and compared against the model. 12 specimens were built and tested. In flexure, empirical data had a percent error with respect to the model ranging from 10.9 to 65.4% with one outlier at 94.1%. In torsion, the empirical data had a percent error with respect to the model ranging from 0.4 to 34%. The test data exhibited similar trends compared to the model. An IsoTruss structure built to maximize torsional rigidity should have a diameter and bay length such that its helical angle is between 55 and 60 degrees. The inclusion of longitudinal members has a negligible impact on rigidity. Flexural rigidity is maximized with longitudinal members and with a minimal helical angle, placing helical members more in the direction of the longitudinal members. In order to minimize flexural rigidity, the longitudinal members should be removed from the design and the helical member angle should be maximized up to 80 degrees.
| Identifer | oai:union.ndltd.org:BGMYU2/oai:scholarsarchive.byu.edu:etd-8033 |
| Date | 01 December 2018 |
| Creators | Jacobson, Jens Garret |
| Publisher | BYU ScholarsArchive |
| Source Sets | Brigham Young University |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | All Theses and Dissertations |
| Rights | http://lib.byu.edu/about/copyright/ |
Page generated in 0.0017 seconds