The efficiency of nuclear reactors can be improved by increasing the operating
pressure of current nuclear reactors. Current CANDU-type nuclear reactors use
heavy water as coolant at an outlet pressure of up to 11.5 MPa. Conceptual
SuperCritical Water Reactors (SCWRs) will operate at a higher coolant outlet
pressure of 25 MPa. Supercritical water technology has been used in advanced
coal plants and its application proves promising to be employed in nuclear
reactors. To better understand how supercritical water technology can be applied
in nuclear power plants, supercritical water loops are used to study the heat
transfer phenomena as it applies to CANDU-type reactors.
A conceptual design of a loop known as the Supercritical Phenomena
Experimental Apparatus (SPETA) has been done. This loop has been designed
to fit in a 9 m by 2 m by 2.8 m enclosure that will be installed at the University of
Ontario Institute of Technology Energy Research Laboratory. The loop include
components to safely start up and shut down various test sections, produce a
heat source to the test section, and to remove reject heat. It is expected that loop
will be able to investigate the behaviour of supercritical water in various
geometries including bare tubes, annulus tubes, and multi-element-type bundles.
The experimental geometries are designed to match the fluid properties of
Canadian SCWR fuel channel designs so that they are representative of a
practical application of supercritical water technology in nuclear plants. This loop
will investigate various test section orientations which are the horizontal, vertical,
and inclined to investigate buoyancy effects. Frictional pressure drop effects and
satisfactory methods of estimating hydraulic resistances in supercritical fluid shall
also be estimated with the loop.
Operating limits for SPETA have been established to be able to capture the
important heat transfer phenomena at supercritical conditions. Heat balance and
flow calculations have been done to appropriately size components in the loop.
Sensitivity analysis has been done to find the optimum design for the loop. / UOIT
Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OOSHDU.10155/229 |
Date | 01 April 2012 |
Creators | Adenariwo, Adepoju |
Contributors | Harvel, Glenn |
Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
Language | English |
Detected Language | English |
Type | Thesis |
Page generated in 0.0014 seconds