Two important areas of physics are spontaneous pattern formation and droplet motion on surfaces. These two areas can be brought together since the texture of a surface can influence its wetting properties. Therefore by controlling the factors that determine the length scales of the patterns during spontaneous pattern formation, it is possible to design surfaces with very specific wetting properties. This was used to create surfaces that could direct the motion of sessile water droplets. Patterned surfaces with micro-wrinkled surface structures were prepared by thermally evaporating thin Aluminium (50−500nm thick) (Al) layers on to thick pre-strained layers of a silicone elastomer and subsequently releasing the strain. This resulted in the formation of sinusoidal periodic surface wrinkles with characteristic wavelengths in the 3 − 45μm range and amplitudes as large as 3.6μm. The Al thickness dependence of the wrinkle wavelengths and amplitudes were determined for different values of the applied pre-strain and compared to a selection of wrinkle formation theories. Samples with spatial gradients in wrinkle wavelength were also produced by applying mechanical strain gradients to the silicone elastomer layers prior to deposition of the Al capping layers. Sessile water droplets that were placed on these surfaces were found to have contact angles that were dependent upon their position. When vibrated close to their resonant frequency, these water droplets were observed to move from regions of short wrinkle wavelength to regions of large wrinkle wavelength. These samples are therefore viable candidates for the production of low cost gradient energy surfaces.
Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:559547 |
Date | January 2012 |
Creators | Langley, K. |
Publisher | University of Nottingham |
Source Sets | Ethos UK |
Detected Language | English |
Type | Electronic Thesis or Dissertation |
Source | http://eprints.nottingham.ac.uk/12335/ |
Page generated in 0.0021 seconds