This thesis describes the novel test techniques that were developed to measure the parameters associated with the plastic shrinkage, and subsequent possible plastic shrinkage cracking, of high strength concrete. The parameters measured during the first 24 hours after placing were the stress- strain relationship, negative pore pressure and free shrinkage strain development. The plastic behaviour of eight high strength concrete mixes was quantified and these mixes were then tested to assess their propensity towards plastic shrinkage cracking, using restrained ring tests. A review of the parameters associated with plastic shrinkage cracking was carried out. The general view was that as the particle size in a cement matrix gets smaller, then the negative pore pressures developed are greater and hence shrinkage increases. This meant that the presence of secondary cementing materials, of very small diameter, such as microsilica, in high strength concretes would explain their apparent susceptibility to plastic shrinkage cracking. Eight high strength concrete mixes were tested in exposed and sealed conditions. It was found that when tested in sealed conditions none of the parameters measured presented itself as the sole driving force behind plastic shrinkage or plastic shrinkage cracking. Also, when cured in sealed conditions, none of the mixes tested in the restrained ring test apparatus cracked. When tested in exposed conditions, the presence of wind had little effect on the stress-strain relationship of the mixes tested. However the presence of wind seemed to cause negative pore pressures to develop earlier than in the sealed samples and increased free shrinkage by 3 to 40 times depending on the mix. The samples that exhibited the highest free shrinkage strains, in exposed conditions, were the mixes that cracked when tested in the restrained shrinkage rings. The mixes that cracked all contained microsilica and these mixes did not crack when the same mixes were tested without microsilica. Polypropylene fibres were found to reduce the cracked area of the samples that cracked. The supplementary cementing materials used in this study were ground granulated blast furnace slag, metakaolin, microsilica and pulverised fuel ash.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:341329 |
| Date | January 2001 |
| Creators | Branch, James |
| Publisher | University of Surrey |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://epubs.surrey.ac.uk/842953/ |
Page generated in 0.0019 seconds